Vacmaster Pro160 User manual - Pro160 Will Not Turn On
Under the proper circumstances, your Pro160 will give you top-notch vacuum
performance. In some instances, problems may arise. Please consult the trouble
shooting menu before calling customer support.
Pro160 will not turn on
▪ Ensure that the machine is properly plugged into a grounded outlet.
▪ Check the power cord for tears and frays. Do not use machine if power cord
is damaged.
▪ Make sure the ON/OFF button was properly pressed. Green light will be on
and LED screen will be illuminated when on.
▪ If the LED screen displays “EO2”. Allow the machine to rest for 3 minutes.
Then press ON/OFF button to resume.
Pro160 does not pull a complete vacuum with bag
▪ If using MANUAL mode, vacuum/seal time may not be set high enough. Set
vacuum and seal times higher, or use AUTO mode, and vacuum again.
▪ To vacuum and seal properly, the edge of bag must be within the sealing strip/
vacuum channel. Make sure bag is inside the sealing strip/vacuum channel
and there are no wrinkles in the bag along the seal bar.
▪ If packaging from a roll bag, make sure the first seal is complete.
▪ Pro160 and vacuum bag need to be clean, dry and free of debris for the
vacuum process to be successful. Wipe surface of seal bar and inside of
bag and try again.
Vacuum bag loses vacuum after being sealed
▪ Sharp items can puncture small holes in bags. To prevent this, cover
sharp edges with paper towel and vacuum in a new bag.
13