Vacmaster vp320 User Manual - Cleaning and Care
www.VacMasterFresh.com | 800-821-7849
Remove the back panel
Remove the screws that hold the Upper Chamber in place -
Two located
on the front corners and two located on the back.
Pull the chamber assembly back about 3-4 inches
Remove the 4 screws that hold the filter plate on the end of the pump
Remove the plate and spring
Remove the exhaust filter
Install new filter - Then
reassemble all of the pieces
in reverse order!
12
Cleaning and Care
Disconnect the power cord from the electrical outlet by unplugging it. DO NOT
disconnect by pulling on the cord.
DO NOT immerse in water or spray directly with liquid.
Check the Vacuum Chamber and Gasket, making sure they are clean and free
of debris. If needed, use a clean, damp cloth with mild soap.
a. Wipe the vacuum chamber clean.
b. Wipe the gasket clean.
c. Wipe the seal area clean.
Do not store the VP320 outside.
DO NOT use any acetone-based or abrasive cleaners on the lid or other plastic
parts. Only clean lid with a damp cloth and mild soap.
•
•
•
•
•
Changing the Filter
1
2
3
4
5
6
7
Plate Screws
(Step #4)