VacuMaid GARAGE VAC Owner's Manual
GARAGE VAC
O W N E R S
M A N U A L
READ BEFORE OPERATING YOUR SYSTEM
Vacuum cleaner won’t run
•
Be sure the unit is plugged in.
•
Be sure you turned the system on.
•
Check circuit breaker on the side of
the unit. If tripped, press to reset.
•
Check your circuit breaker panel.
Make sure there is not too much on
that circuit causing it to trip.
Blowing function is not working
•
Be sure your hose is plugged into the
exhaust hole on the side of the unit.
•
Be sure you have the additional cuff
inserted in the utility valve on the
front of the unit. If this door is not left
open, the blowing feature will not
work properly.
Low suction or no suction
•
First, see above.
•
Usually low suction is caused by a full
filter. Change your filter bag. See
Operating Instructions for details.
•
Is the dirt canister lid off or loose?
Be sure the lid is replaced squarely on
the top of the canister and that the
gasket has not been pulled loose or it
could allow a vacuum leak. If gasket is
loose, reattach with contact cement
or super glue.
•
Is there blockage in the hose or tools?
Disconnect the hose from power unit,
use a blunt item to push the clog out.
If the blockage is in the tools, remove it.
Most problems that develop can be fixed easily by following the below suggested solutions:
L6232
PO Box 1708
Ponca City, OK 74602
1-800-546-3729
TROUBLESHOOTING
For replacement bags or to order additional
tools or accessories, visit us at
www.vacumaid.com
or give us a call at
1-800-228-0285
To register your product online, go to
www.vacumaid.com/registration