V110-h multistage pump instruction manual.
Construction pump casing x5 crni 1810 (aisi 304) stainless steel motor bracket die-cast aluminium impeller technopolymer with x5 crni 1810 (aisi 304) stainless steel shim ring diffusors technopolymer shaft x12 crnis 1809 (aisi 416) stainless steel mechanical seal graphite counterface ceramic seal ho...
Table of hydraulic performance pump performance pump dimensions model nominal power absorbed power voltage amp µf q l/1’ 0 20 40 60 80 100 hp kw hp kw m3/h 1.2 2.4 3.6 4.8 6 v110-h 1.2 0.9 1.7 1.25 1~230v 5.8 20 discharge head in meters 60 55 48 36 26 10 model dimensions (mm) weight a b c d suction ...
Vada - v110-h preparing for installation inspect your pump, ensuring that it is well packaged and has not been damaged in transport. If the pump is damaged, report it to the reece branch where the pump was purchased. Make sure the suction piping is completely air tight and is laid so that there can ...
General installation 1. Fitting an auto pressure control or mains water switch over device if you are using a vada auto pressure control or a mains water switch over device with your pump, connect it either directly to the top of the pump or in a suitable position in line with the delivery piping. F...
Fire and burn hazard. Modern motors run at high temperatures. To reduce risk of fire, do not allow leaves, debris, or foreign matter to collect around the pump motor. To avoid burns when handling the motor, let it cool for at least 20 minutes before trying to work on it. A thermal overload switch pr...
Trouble shooting guide symptom cause remedy the motor will not start, no water is pumped no electricity ensure that the pump is connected to a live outlet motor protection tripped verify the cause and reset the switch. If the thermal circuit breaker has tripped wait for the system to cool down defec...
Disclaimer: products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions and set-outs listed are correct a...
