V75-s submersible pump instruction manual.
Construction pump body x5 crni 1810 (aisi 304) stainless steel suction grid x16 crni 16 (aisi 431) stainless steel base noryl impeller acetal resin diffuser polycarbonate with ceramic insert in the point of wear diffuser cap polycarbonate with stainless steel inserts in the point of wear motor shaft...
Table of hydraulic performance pump performance pump dimensions model nominal power absorbed power voltage amp µf no. Stages q l/1’ 0 20 40 60 80 hp kw hp kw m3/h 1.2 2.4 3.6 4.8 v75-s 0.8 0.6 1 0.75 1~220/240v 3.3 16 8 discharge head in meters 56 49.8 38.1 19 model dimensions (mm) weight a Ø c free...
Preparing for installation inspect your pump, ensuring that it is well packaged and has not been damaged in transport. If the pump is damaged, report it to the reece branch where the pump was purchased. Warranty of these pumps is void unless they are operated in accordance with these instructions. P...
General installation 1. Fitting an auto pressure control or mains water switch over device if you are using a vada auto pressure control or mains water switch over device with your pump, it needs to be mounted externally to the tank in a suitable position in line with the delivery piping. This can b...
The pump is designed to be used with clean water in a residential application. Do not use it with alternative fluids, specifically abrasive, corrosive or explosive fluids. Do not install or operate your pump in an explosive enviroment or near combustible matter. Liquid may be hot, release pressure w...
Trouble shooting guide symptom cause remedy the motor will not start, no water is pumped no electricity ensure that the pump is connected to a live outlet motor protection tripped verify the cause and reset the switch. If the thermal circuit breaker has tripped wait for the system to cool down defec...
Disclaimer: products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions and set-outs listed are correct a...
