VADDIO CCU 300 Installation and user manual
Installation and User Guide
Camera and Electronic Products for Integrators
©2008 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and
pricing subject to change. Vaddio, WallVIEW, HSDS, Quick-Connect, EZIM, ProductionVIEW, PreVIEW, EZCamera and PowerRite are
registered trademarks of Vaddio. All other trademarks are property of their respective owners. Document Number 341-720 Rev B.
W
ALL
VIEW™
CCU
300
WITH
HSDS™
Vaddio™ Quick-Connect™ CCU for the
Sony® BRC-300 PTZ Camera
OVERVIEW
The Vaddio WallVIEW CCU 300 (Figure 1) is built around the
Sony BRC-300 standard definition PTZ Camera. The
WallVIEW CCU 300 allows the user to control the color output
of the camera’s image sensor, through both Red and Blue
Gain knobs, as well as Iris and Gain levels and Aperture, to
provide a higher quality image. The system uses high speed
differential signaling (HSDS), an active transmission system
that delivers low-loss, high-quality video over CAT-5 cabling
distances up to 500 feet. The WallVIEW CCU 300 system is
capable of standard definition (SD) resolutions in a variety of
screen configurations to fit most monitors. The BRC-300 is
offered in either NTSC or PAL formats.
The WallVIEW CCU system also has many new features, including Tally illumination on the camera which
allows the presenter to know which camera is live, as well as Genlock delivered to the camera over CAT-5.
Other new features include the ability to store settings on two discrete Scene buttons, and buttons for Auto
White Balance, One Push White Balance and Auto Iris. Like all Vaddio WallVIEW systems, the Thin Profile
Wall Mount and mounting hardware is included.
INTENDED USE
Before installing the Vaddio WallVIEW CCU Camera System, please read the entire manual thoroughly. All
Vaddio camera systems are designed for use indoors. Outdoor operation is not recommended, has not been
tested, and could damage the camera and/or create a potentially unsafe operating condition. Use only the
Vaddio PowerRite power supply provided.
SAVE THESE INSTRUCTIONS
The information contained in this manual will help you install the Vaddio WallVIEW CCU system. For
reference, Vaddio keeps copies of Specifications, Installation and User Guides and most pertinent product
drawings for the Vaddio product line on the website. These documents can be downloaded from
www.vaddio.com free of charge.
IMPORTANT SAFEGUARDS
Read and understand all instructions before using. Do not operate any electrical device if it has been
dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To
reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid
conditions.
INFORMATION
For RS-232 control information, please see the full-length Technical Manual for the SONY BRC-300. This
manual can be found either on the Vaddio or Sony website. Vaddio has also prepared a number of
TechNotes, specifications and drawings designed to inform and educate integrators on the value and the
specific uses of Vaddio products.
Figure 1:
WallVIEW CCU 300 System with Camera,
Wall Mount and EZIM CCU (behind camera)
Use only the power supply provided with the Vaddio WallVIEW products.
Use of any unauthorized power supply will void any and all warranties.