VADDIO CeilingVIEW SD CCU Installation And User Manual - page 3
CeilingVIEW SD CCU
Vaddio CeilingVIEW SD CCU Installation and User Guide - Document 341-769 Rev. A
Page 3 of 16
Camera Module
For video reference, LED power light, IR window and Dip Switch cover will be oriented to the bottom of the
image displayed (shown in Figure 2). Take this into consideration when positioning the camera module. The
supplied mounting rails may need to be used for additional support of the camera on the ceiling tile to
distribute the weight of the camera into the grid and avoid tile warping.
Step-by-Step Assembly Instructions:
1. Attach a string or plumb bob to the ceiling tile with a thumbtack.
2. Position the string directly over the table or work surface to allow easy document and object
positioning.
3. Using a sharp utility knife, score a 5-3/4” diameter circle into the front of the tile centered on the string.
4. Carefully cut out the 5-3/4” hole.
5. Place the tile support rails on the backside of the tile and center over the hole. Carefully place camera
into the cutout hole from the back of tile (see Figure 3).
Figure 3:
Side View of CeilingVIEW
SD Camera Enclosure
shown with Tile Supports
and Trim Ring in place.
Figure 2:
Top of Document Image
Camera Lens
IR Window
Dip Switch Access Cover for IR
Remote and Image Resolution
(See Figure 6 for proper
settings)
Bottom of Document Image
Laser Pointer and
adjustments
LED Power Light