VADDIO PowerVIEW HD-22 Installation And User Manual - page 8
PowerVIEW HD-22 and HD-30
PowerVIEW HD-22 and HD-30 HD PTZ Cameras Document Number 342-0626 Rev A
Page 8 of 16
Image: Basic Connectivity Example of the HD-22 & HD-30
Camera Connected to ProductionVIEW™ Precision Camera Controller, Codec and Monitors
Installation Basics:
Locate the camera mounting location paying close attention to camera viewing angles, lighting conditions,
possible line of site obstructions, and checking for in-wall obstructions where the camera is to be mounted. Pick
a mounting location that will optimize the performance of the camera.
RS-232 Cabling:
For RS-232, use a standard Cat-5 cable (568B termination for RJ-45 connectors) from the RS-232 port on the
back of a Vaddio ProductionVIEW camera controller or switcher. If the camera will be connected to a third-party
control system (such as AMX or Crestron), a DB-9 to RJ-45 adapter is supplied with the camera for RS-232.
.
Rear of
ClearVIEW
HD-22/30
RS-232
YPbPr
12VDC, 3.0A
PowerRite
Power Supply
(Local)
HD Monitor (Simulated Video Feeds)
ProductionVIEW Precision Camera Controller
Other YPbPr FEED
HDMI