VADDIO WallVIEW 50i PTZ Installation and user manual
Installation and User Guide
Camera and Electronic Products for Integrators
Ⓒ2006 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing are
subject to change without notice. Vaddio, WallVIEW, ControlVIEW, EZCamera, Quick-Connect and PowerRite are registered trademarks of
Vaddio. All other trademarks are property of their respective owners. Document Number 010-2201-000 Rev. F
Page 1 of 8
WallVIEW™ PTZ Systems
WallVIEW 50i PTZ, WallVIEW 100 PTZ and WallVIEW 70 PTZ
Pan/Tilt/Zoom Camera Systems
INTRODUCTION
The Vaddio WallVIEW PTZ Camera Systems are complete wall-mounted camera
packages featuring the Vaddio EZCamera™ Cabling System that allows the installer to
use Category 5 cabling to run power, video and camera control. The included
PowerRite™ power supply provides the right amount of power required for proper
operation of the camera over Cat. 5 cabling.
INTENDED USE
Before installing the Vaddio WallVIEW PTZ Camera Systems, please read
the entire manual thoroughly. All Vaddio camera systems were designed
for use indoors. Outdoor operation is not recommended, hasn’t been
tested, and could damage the camera and/or create a potentially unsafe
operating condition. Use only the Vaddio PowerRite power supply
provided.
IMPORTANT
SAFEGUARDS
Read and understand all instructions before using. Do not operate any
electrical device if it has been dropped or damaged. In this case, a Vaddio
technician must examine the product before operating. To reduce the risk
of electric shock, do not immerse in water or other liquids and avoid
extremely humid conditions.
Figure 1: WallVIEW Systems (left to right); WallVIEW 50i PTZ, WallVIEW 100 PTZ, WallVIEW 70 PTZ, with each camera showing
EZCamera Cabling Shoe and Thin Profile wall mount bracket.
Use only the power supply provided with the Vaddio WallVIEW products.
Use of any unauthorized power supply will void any and all warranties.