VAG-Navisystems NaviTouch Android Assembly Instructions Manual - page 7
Manual is about: for RNS-510
of
12
7
8. Connecting the display’s touch flexos to the sub-board:
First, connect the “wiring harness + kit’s flexo” (1) coming out from the display, to the sub-board’s touch
out connector (1 “TS-OUT”). Connect the “additional flexo” (2) to the sub-board’s touch input (2 “TS-IN”).
Connecting the sub-board to the RNS-510
2
1
2
1
9. Now,
connectar the “LVDS cable”
(included on the kit’s package), to the
sub-board. Also connect the system’s
“Touch cable” to sub-board’s the “TS-
IN (NAVI)” connector that you can find
between the two flexo blocking
clamps ocupped by display’s touch
flexos.
Touch cable
LVDS cable
* Sample image, without the display’s rear metal cover installed.