Installation instructions gb, ie vr 66 control centre vr 66 installation instructions for the competent person.
- 1 - 1 notes on the documentation ......................................................................................................... 2 1.1 symbols used .....................................................................................................................2 1.2 observe other app...
- 2 - introduction 0020140122_02 - 05/13 en 1 notes on the documentation 1.1 symbols used the symbols used in the text are explained below: symbol explanation i symbol that denotes useful tips and information ∙ symbol for a required action the warning notes are classifi ed in accordance with the sev...
- 3 - introduction en 0020140122_02 - 05/13 2.1.5 danger of scalding due to the hot water! ∙ there is a danger of scalding at the hot water draw-off points if the hot water temperatures are higher than 60°c. Young children and elderly persons are particularly at risk, even at lower temperatures. ∙ se...
- 4 - introduction 0020140122_02 - 05/13 en - the health and safety at work act, control of substances hazardous to health (coshh). - any electrical work must conform to bs7671 and part p of the building regulations where applicable. Where no specifi c instructions are given, reference should be mad...
- 5 - introduction en 0020140122_02 - 05/13 3.2 product structure 3.2.1 m onozone operation mode t he monozone operation mode is compatible with: - ebus controllers range (vrt 392, vrt 392f, vrt 350, vrt 350f, vrc 430, vrc 430f, vrc 470, vrc 470f) - s ystem and open vent boiler i t allows the contro...
- 6 - introduction 0020140122_02 - 05/13 en 3.2.3 monozone mode : open vent or system boiler with dhw cylinder, 3-port valve ebus ebus 1 2 - + bus ntc l n l l 16a 230v~ cyl. Dhw ch1 ch2 2 1 bus 16a nl bus on dhw off 1m min. 1 2 - + bus ntc l n l l 16a 230v~ cyl. Dhw ch1 ch2 2 1 on dhw off 1 1 bus 16...
- 7 - introduction en 0020140122_02 - 05/13 3.2.4 monozone mode : open vent or system boiler with dhw cylinder : two 2-port valves ebus ebus 1 2 - + bus ntc n l n l 16a 230v~ cyl. Dhw ch1 ch2 2 1 on dhw off 6 4 3 5 1 2 - + bus ntc n l n l 16a 230v~ cyl. Dhw ch1 ch2 2 1 on dhw off 1 1 bus 16a nl bus ...
- 8 - introduction 0020140122_02 - 05/13 en 3.2.5 multizone operation mode the multizone operation mode is compatible with: - vrt350 - system, combi and open vent boiler the information about the heating or hot water demand is sent to the room thermostat via the control unit to the boiler. The vr66 ...
- 9 - introduction en 0020140122_02 - 05/13 3.2.6 multizone mode : open vent or system boiler with dhw cylinder ebus ebus 1 2 - + bus ntc n l n l n l ebus 16a 1 2 - + bus ntc n l n l n l 230v~ cyl. 2 1 16a 230v~ cyl. 2 1 bus bus 16a nl bus bus bus 16a nl bus dhw ch1 ch2 on dhw off 0 0 16 15 10 10 2 ...
- 10 - introduction 0020140122_02 - 05/13 en 3.2.7 multizone mode with combi boiler ebus ebus ebus 1 2 - + bus ntc n l n l 16a 230v~ cyl. Dhw ch1 ch2 2 1 bus bus 16a nl bus on dhw off 0 0 10 9 8 2 a b d 5 6 11 7 3 8 5 6 1 2 3 7 4 1 c key 1 vrt350 thermostat "zone 1" 2 combi boiler 3 vrt350 thermosta...
- 11 - 0020140122_02 - 05/13 installation en 3.3 type designation and serial number data plate location: 1 3.4 data plate description the data plate certifi es the country where the product is intended to be installed. The data plate contains the following data: abreviation/symbol description brand ...
- 12 - 0020140122_02 - 05/13 installation en 4.2.2 wall-mounting of the product the control unit is designed to be attached to a wall near the main tank inside a dwelling. 3 3 4 1 1 2 2 235 key 1 screws 2 attachment holes 3 holes 4 plugs ∙ determine the position depending on the requirements of the ...
- 13 - 0020140122_02 - 05/13 installation en 24v connectors (low voltage) 230v~ cyl. 2 1 dhw ch1 ch2 on dhw off 1 2 - + bus ntc 1 2 - + bus ntc 1 2 key 1 ebus connector (2 pins) 2 ntc connector (2 pins) 4.3.2 main board 20 mm max. 2 1 key 1 electrical wires 2 casing when you connect the electrical w...
- 14 - 0020140122_02 - 05/13 maintenance en 6 user information at the end of the installation, the installer must: - explain the operation of the appliance and its safety devices to the user, if necessary provide a demonstration and answer any questions; - give the user all the required documentatio...
- 15 - 0020140122_02 - 05/13 technical data en 8 decommissioning ∙ switch off the product. ∙ isolate the product from the power mains. ∙ de-install the product. ∙ recycle or dispose the product and its components (see chapter 9). 9 recycling and disposal 9.1 recycle the packaging - sort the waste to ...
Manufacturer supplier subj ect to engineering ch ang es 0020140122_02 - 05/13.