Valco Baby REBEL Q Product Reference Manual - page 4
FOOTREST ADJUSTMENT
FIGURE I - FOOTREST ADJUSTMENT
27. To adjust your footrest, simultaneously press the
two adjusting buttons on either side of the footrest
and move it up or down to the desired position.
SEAT ADJUSTMENT
FIGURE J - SEAT ADJUSTMENT
28. Your stroller seat has 4 recline positions.
29. To recline the seat simply lift the recline handle
located on the back of the seat and ease the seat
down into the required position.
30. For seat incline, gently push the seat upward into
the desired upright position. It is not necessary to
lift the recline handle.
NOTE: SPECIAL CARE MUST BE TAKEN WHEN
ADJUSTING THE SEAT POSITION WITH A CHILD IN
THE STROLLER.
HOOD
FIGURE K- HOOD INSTALLATION
31. Insert the plastic hood legs into the
corresponding housing on either side of the
stroller frame.
32. To remove your hood; Feeling the side of the
nylon housing that sits below the frame at each
side (facing inward), locate the hood release tabs.
33. Press the hood release tabs inward while
simultaneously lifting the hood upward. Repeat for
the other side.
FIGURE L- USING THE HOOD
The Expanda hood unzips, increasing the size of
your standard hood to give greater coverage and
protection from the sun and weather for your child.
To open the Expanda Hood:
34. Locate the zip in the center of the Expanda Hood
and unzip completely. Gently pull the Expanda
Hood forward until it reaches its full extension
To close the Expanda Hood
35. Gently push the Expanda Hood back, allowing
the middle section to fold in on itself. Carefully zip
the Expanda Hood closed.
IMPORTANT: always take care when closing the
Expanda Hood to avoid the zipper catching on the
ENCLOSED fabric
I
push
I
click
lift
26
J
K
L