Valco Baby TRAVEL SYSTEM ADAPTOR Product Reference Manual - page 2
aDaPTOR aSSEMBLY
FIGURE A
1. Remove the Car Seat Adaptor from packaging. Dispose
of all packaging thoughtfully. Identify all parts on the
Adaptor:
a. Adaptor Fixing brackets
b. Front locking hooks
c. Back locking uprights
FIGURE B
2. The Valco Travel System is made to accommodate the
Britax Unitiy™ Car seat.
FIGURE C - INSTALLING THE ADAPTOR
3. Recline the seat of your stroller as far as it allows and
push the hood back completely. Remove the bumper bar
as per the manufacturer’s instructions and store in a
safe place.
4. Position the Adaptor so the front locking hooks (a) face
forward (4).
5. Position the Adaptor directly over the stroller seat and
align the adaptor fixing brackets with the bumper bar
housings.
6. Lower the Adaptor carefully into the bumper bar housings
until both sides engage into place.
IMPORTaNT NOTE: aLWaYS TEST THaT THE CaR SEaT
aDaPTOR HaS BEEN FULLY ENGaGED INTO POSITION
BEFORE aTTaCHING YOUR CaR SEaT.
FIGURE D - USING YOUR TRAVEL SYSTEM
7. Tilting the car seat slightly, align the locking bracket at
the rear of the seat with the front locking hooks (b) on
the adaptor.
A
B
C
D
a
a
c
c
b
b
b
4