Product reference guide read and follow the instructions contained within carefully before use. Retain this guide in a safe and easily accessible place for future reference. Drawings, pictures and specifications contained in this manual are for illustration purposes only – actual product may vary. V...
Thank you for purchasing a quality valco product. Due to our policy of continuous product development, this product is constantly evolving. It is possible that some features or procedures outlined here have changed since this document was written. If you are unsure of any procedure outlined here ple...
1 x chassis installed with seat liner and basket basic components 2 x front forks & front wheels 2 x rear wheels 1 x rear axle-brake system 2 x rear axle pins (sqr axles) 2 x hoods (left & right side) 1 x twin runabout front bar 4 x nylon housing bracket plugs.
Remove the stroller from the carton and dispose of all packaging immediately including the black rubber protectors on either side of the brake bar and front wheel protector. The front wheel forks, rear wheels, front bar, and hood all need to be installed prior to use. Stroller assembly 1. Take the r...
Important warning: always test that all latches are securely engaged before use. Installing/removing the rear wheels unfold the chassis: 1. Holding the rear centre leg, lift the stroller upwards. 2. Pull the centre leg outwards as far as it can go. 3. Lift the handle upward and back to a vertical po...
Installing/removing and using the front wheel forks pressing the axle button, insert the protruding long axle into the opening in the axle tube. (refer to ‘using your brakes’) note: ensure that the brake pedal is fully retracted, so that the brake pin (highlighted in red) does not obstruct the wheel...
The unique tri-mode™ swivel system is as flexible as it is functional over a variety of terrains and uses. 1. Lock: this position is best for use on extremely rough or soft terrain such as sand etc which inhibit wheel swivel. To lock your wheel, rotate the dial to the “lock” position. Swivel the whe...
4. Slide the hood housing downward, engaging the track in the channel, continue sliding downward until the rivet outside (d) is fully engaged in the housing. 5. Repeat the procedure for the other hood. 6. Secure each hood to the rear of the frame with velcro straps at the centre (e), and both sides ...
Using your brakes 1. Remove the plugs from the nylon housing at either side of the stroller frame by pressing each inner “release button” and pulling the plug upward. Note: do not remove the plugs in the centre between both seats. Be sure to store the removed plugs in a secure place as they must be ...
Folding/opening your stroller 1. Fold the hood back up against the handle. 2. Release the locking clamps at either side of the stroller. 3. Simultaneously lift the secondary safety catch (located at the left hand side of the stroller while standing behind) and swing the handle forward. 4. Holding th...
Your twin runabout stroller is equipped with a tyre pump that hangs in a special pocket found sewn beneath the right hand seat at the rear. Your tires should be kept at a pressure of 40 psi (hard when pressed). Under- inflated tyres can cause excessive and uneven tire wear, greater susceptibility to...
Uv protective insect net our unique insect net zips directly in to the inside of your runabout tri mode hood. In addition to keeping baby cool, comfortable and safe from insects, it also blocks up to a massive 80% * of the sun’s harmful uv rays. (* tested to australian standard 4399) your twin runab...
To secure your child in the harness: 1. Overlap buckles (a) and (b) so that they fit together to form one complete buckle. 2.Insert the completed buckle into the buckle housing (c) until it engages securely in place. 3.Carefully adjust the harness straps to snugly fit your child by adjusting the sli...
Optional/additional accessories toddlerseat available in versions for both single and twin runabout models, the optional toddlerseat sits firmly inside the chassis. Perfect for twins and an older sibling (twin model) or when a new baby comes along and junior still likes to go for a ride! Both twin a...
The valco hitchhiker is a boon to any parent with a child who is old enough to walk but young enough to need to rest along the way. Made of high quality and extremely sturdy materials (maximum weight 30 kg’s / 66 lb’s), the hitchhiker is easily adjustable for height, width and distance from the stro...
Warnings your child’s safety is your responsibility ……… • besure to check that all clamps and buckles are securely fixed and in place before use. • check all parts for breakage or fatigue before use. Discontinue immediately if any part is found to be damaged or broken. • the maximum weight of the ch...
