Valcom V-1001 Install Manual

Issue 0

1

947062

V-1001

P-TEC SURFACE MOUNT

AMPLIFIED CEILING SPEAKER

INTRODUCTION

The V-1001 is a surface mounted speaker that

is self-amplified and is capable of reproducing

voice paging as well as background music. The

V-1001 has an externally accessible volume

control that can be adjusted by a screwdriver

through the side hole on the housing. All

speakers require -24VDC, 50mA.  The baffle is

designed for mounting on acoustic tile, such as

those normally found in suspended-ceilings and

can be mounted without cutting large holes in

the tile.  The mounting pins can be removed for

mounting in a hard ceiling.  The speaker

housing has screw holes for securing speaker

without mounting pins.  Although the P-TEC

speakers are designed specifically for standard

suspended ceilings, they can be used on many

types of ceiling materials. Two pair category

3/5/5E/6 UTP cable recommended.

INSTALLATION (

see Figure 1

)

1.  Lift the adjacent ceiling tile and slide it out of

the way. 

2.  Pierce hole in tile where speaker is to be

mounted with a screwdriver.  Feed wire

through hole to connect to speaker.

3.  Make connections to amplifier (see Figure

2). 

4.  Install the speaker by inserting the mounting

pins through the ceiling tile and hold the

speaker in place.

5.  Place the speaker mounting clips over

mounting pins (so pins slide through clips).

6.  If necessary, adjust paging volume after

installation.  The volume control is located

on the side of the speaker.  Use a small

screwdriver to turn the control.

7.  Install the volume control cover found in the

accessory pack.