Valcom V-2924A User Manual - page 3
Manual is about: TALKBACK INTERCOM SYSTEM EXPANDABLE 24/48/72/96 ZONE
of
13
3
HIGH VOLTAGE AREA
DISCONNECT POWER
BEFORE SERVICING
J3
J4
Install
Standoffs
Here
FIGURE 1 - CLOCK CARD PLACEMENT ON THE CONTROL BOARD
Side View
Top View
P10 P1
RS232 Serial Port
for SMDR (DB9
Connector)
PC Programming
Port (located on
Option Board)
J1 and J2 are located on the under
side of the Clock Card
Clock Control
Card Port
(located on
Clock Card -
DB15 Connector)
Remove and
discard plate
covering
connector port
P2
Align J1 on the Clock Card directly over J3.
Align J2 on the Clock Card directly over J4.
Press V-2927 firmly in place.
Clock Card
positions
directly over
the Option
Board