Valcom V-5330100 User Manual

Issue 2

1

947165

P-TEC VOICE PAGING SPEAKERS

V-5330100 (VOICE COIL)

V-5330200 (70 VOLT)

by

PagePac

®

INTRODUCTION

P-TEC Voice Paging Speakers are suitable for 

voice paging as well as background music. The  

V-5330200 is a 70 volt model with adjustable taps 

and volume control.  The V-5330100 is a voice coil 

(45 Ohm) 3.4 volt model with volume control.

P-TEC speakers consist of a 3.6 inch cone 

speaker mounted in a unique surface-mount baf-

fle.  The baffle is designed for mounting on  

acoustic tile, such as those normally found in sus-

pended-ceilings; and can be mounted without  

cutting large holes in the tile.  The mounting pins  

can be removed for mounting in a hard ceiling. 

The speaker housing has screw holes for securing 

speaker without mounting pins. Although the

P-TEC speakers are designed especially for stan-

dard suspended ceilings, they can be used on 

many types of ceiling materials.

DIMENSIONS/WEIGHT

• 8”Dia. x 2.5”D (20.32cm x 6.35cm)

Voice Coil   .75 lbs. (.34 kg)

70 Volt       1.25 lbs. (.56 kg)

INSTALLATION

Selecting the Power-Tap Wire (70V)

Note: For the V-5330100 Speakers (Voice Coil),

          begin at Suspended Ceiling Installation.

1. Remove the Quick-Connect connector from 

the accessory pack.

2. Select the desired power-tap wire:                

Yellow = 1/4W

Red

= 1/2W

Green = 1W

White = 2W

Blue

= 4W

Note:  Refer to spacing chart (Figure 6) for recom-

mended speaker spacing.

Figure 1. P-TEC Paging Speaker (70V shown)

3. Install the Quick-Connect connector on the 

wire. Use pliers to close the connector over 

the wire.  The connector can be removed by 

prying it open with a screwdriver, and can be 

reused several times (see Figure 2).

Figure 2. Attaching the Reuseable Quick-Connect

               Connector (V-5330200 Only)

Back Box (Optional)

Volume Control

Reusable

Quick-Connect

Connector

Tap Wire