Valcom V-9941A User Manual

Other manuals for V-9941A: User Manual, Datasheet

Summary of V-9941A

  • Page 1

    Issue 5 1 947960 v-9941a one zone handsfree talkback control unit introduction the v-9941a is a one zone handsfree page unit for use on an electronic key system line key position, a pabx loop start trunk port, a dedicated single line telephone or a 600 ohm two-way page port with a contact closure. T...

  • Page 2: System Design

    2 dimensions/weight 8.25" h x 4.65" w x 2.30" d (20.96cm h x 11.81cm w x 5.84cm d) 1.5 lbs. (0.68 kg) power requirements 21.5 to -26vdc "b" battery, 300ma maximum environment temperature: 0 to +50° c humidity: 0 to 85% (non-precipitating) system design general the valcom v-9941a talkback control uni...

  • Page 3: Installation

    3 installation wiring instructions: place a check by each step as it is completed: __ 1. Connect tip of the telephone system trunk position to the v-9941a terminal 1 (tip). __ 2. Connect ring of the trunk port to the v-9941a terminal 2 (ring). __ 3. Connect tip and ring of the talkback speakers to t...

  • Page 4

    4 wiring instructions: __ 1. Connect tip of the telephone system 600 ohm page port to terminal 1 (tip) of the v-9941a. __ 2. Connect ring of the 600 ohm page port to terminal 2 (ring). __ 3. Connect one side of the telephone system dry contact closure to terminal 3 (gnd) of the v-9941a. __ 4. Connec...

  • Page 5: Operation

    5 w/bl bl/w v-9941a connecting block t r telephone system c.O. Line position or loop start trunk port t r a a1 br/w bl/r inhibit 5.1k ohm connections for inhibit option ground volume adjustments there are two volume controls on the v-9941a. The control on the left adjusts the speaker to phone level ...

  • Page 6: Technical Assistance

    6 technical assistance when trouble is reported, verify that power is being supplied to the unit and there are no broken connections. Check voltages for proper polarity on the cross connect block. Table 1 identifies symptoms of some possible problems with solutions. If a spare unit is available, con...

  • Page 7

    7 simplified schematic note: specifications are subject to change without notice. Troubleshooting chart problem possible solution 1. No talk battery on tip and ring 2. No paging at speaker 3. Paging at speaker but no reply from speaker a. Verify good connections on terminals 1 (tip), 2 (ring), 3 (gn...