Valcom VIP-401 User Manual
Issue 1
1
947198
Issue 4
VIP-401, VIP-402, VIP-402-EC
LAY-IN ONE-WAY IP CEILING SPEAKER
INTRODUCTION
The VIP-401/VIP-402/VIP-402-EC Lay-In One-Way
IP Ceiling Speakers enable voice access to a single
zone of one-way paging over an IP-based
LAN/WAN. This allows a page zone extension
anywhere on the network. The speaker level is
electrically adjusted during setup. The lay-in ceiling
speaker grille is made of steel with a white baked
enamel finish. The VIP-
401 replaces ½ of a 2’ x 2’
ceiling tile. The VIP-402 replaces
a 2’ x 2’ ceiling
tile. The VIP-402-EC replaces a 600mm x 600mm
ceiling tile. Power is provided to the unit via a
Power over an Ethernet (PoE) switch meeting the
802.3af specification.
SPECIFICATIONS
Access Methods
PBX, FXO Port w/VIP-811
POTS telephone set w/VIP-811
PBX, FXS Port w/VIP-821
Valcom M Cast Page Group
SIP
– enabled telephone system
Features
RJ-45 network connection
Power over Ethernet (PoE) 802.3af compliant
High Efficiency Class-D Amplifier
INSTALLATION
Dimensions/Weight
VIP-401:
23.75” L x 11.75” W x 3.75” D
(60.33cm) x (29.85cm) x(9.53cm)
Weight: 5.5 lbs. (2.49kg)
VIP-402:
23.75
” L x 23.75” W x 3.75” D
(60.33cm) x (60.33cm) x(9.53cm)
Weight: 5.5 lbs. (2.49kg)
VIP-402-EC:
594mm L x 594mm W x 9.53mm D
Weight: 5.5 lbs. (2.49kg)
Environment
Temperature:
0 to +40° C
Humidity:
0 to 85% non-precipitating
Precautionary Designations
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates uses, and can radiate radio
frequency energy and if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference in which case the
user will be required to correct the interference at
his own expense.
Packing List
Qty.
Item
1
Lay-in Ceiling Speaker
1
VSP Document
1
RJ-45 Patch Cables