Valcom VIP-801A-IC Installation

1 947831 

CAUTION:  To reduce the risk of electric shock,

Do not remove cover.

No user serviceable parts inside.

Refer servicing to qualified service personnel.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol indicates that dangerous

voltage constituting a risk of electric

shock is present within this unit.

This symbol indicates that there are

important operating and maintenance

instructions in the literature accompanying

this unit.

           Issue 1 

VIP-801A-IC 

InformaCast

®

 Compliant 

Network Audio Port  

INSTALLATION 

Mounting 

The VIP-801A-IC is designed for wall or table 

mounting. 

Table: Provided with the VIP-801A-IC are four 

rubber pads.  Peel the pads from their carrier 

backing and place at the four corners of the 

bottom of the unit. 

Wall: Using the brackets and screws provided, 

secure the VIP-801A-IC to the wall. 

INSTALLATION

FCC Information 

This equipment has been tested and found to 

comply with the limits for a Class A digital 

device, pursuant to Part 15 of the FCC Rules.  

These limits are designed to provide 

reasonable protection against harmful 

interference when the equipment is operated 

in a commercial environment.  This 

equipment generates, uses and can radiate 

radio frequency energy and if not installed 

and used in accordance with the instruction 

manual, may cause harmful interference to 

radio communications.  Operation of this 

equipment in a residential area may cause 

harmful interference in which case the user 

will be required to correct the interference at 

his own expense.          

Precautionary Designations 

Power Connections 

The preferred method of powering a              

VIP-801A-IC is via a power over Ethernet switch 

meeting the 802.3af specification.  If the rear 

panel barrel connector is used for power, the 

preferred power supply is a Valcom VIP-324D. 

Make all required signal connections before 

applying power to the unit.  If powering via 

802.3af Power over Ethernet (PoE), make sure 

all signal connections via the back panel are 

made then connect the VIP-801A-IC to the 

Ethernet switch.  

If power is supplied via the barrel connector, 

make sure all signal connections are secure.  

Attach the unit to the network via the front panel 

RJ-45 Ethernet connector. Apply power by