Valet N517 Quick Start Manual - Note
Basic Remote Control Functions
Press
Red Button
ARMING
Full System Turning On – all detectors will be activated to trigger the alarm
system. This mode is to be used when there is no one staying at the
premises.
TO TURN ON the system in AWAY mode, press Red button for 1 second.
You will hear 1 beep from the main unit. There is a 20 second exit delay i.e.
the alarm can not be triggered by a detector until 20 seconds after arming –
in other words you have 20 seconds to exit the protected area.
Press once to arm
the system fully
Press and hold
(approximately 3
seconds) to
activate PANIC
mode
PANIC
Personal Alarm – this is used to set the siren into alarm so that people in
the surrounding area are made aware that there is a problem at your
premises.
To activate panic press and hold down Red button until the siren is set into
alarm (approximately 3 seconds). The alarm will turn on i.e. siren will beep
once and strobe will flash, and then the siren will sound for 5 minutes if not
turned off beforehand.
To deactivate panic press Green button for 1 second. The siren will stop and
the system will disarm.
Press
Green Button
Press once
to disarm the
system
DISARMING
TO TURN OFF the system, press Green button for 1 second. You will hear
2 beeps from the main unit.
Note
For full remote functions refer to Section 3.1 in your main instruction manual.
)
(
(