Valet video intercom vbc plus system installation guide user guide please read and understand this manual before installing and operating 1.
Contents 2 video intercom system 1. Intercom monitor and handset 3 2. Doorbell/camera 4 3. Instalment method and wiring diagrams 5-9 4. Operation instructions 10 5. Technical specifi cations 11 6. Notes 12 page.
Volume dc in ring volume adjust js-vp js-ap jp-lk jp-vd 1. Intercom monitor and handset 1. Screen 2. Indicator 3. Monitor button 4. Intercom button 5. Door key button 6. Phone handset 7. Loud speaker 8. Brightness adjustment 9. Contrast adjustment 10. Hang up latch 11. Ringing volume 12. Js-vp port ...
2. Door bell/camera 128(h )x 98(w) x 43(d) 1. Camera 2. Speaker 3. Call button 4. Microphone 5. Connecting terminal 6. Terminal for door-release 7. Back board 8. Access bracket instalment screws: m4 5pc doorbell camera bracket m6 1pc monitor mounting bracket 1 2 3 4 5 6 8 7 4 power supply adapter 3....
4. Monitor / handset installation note: an expansion module pcb is required to be fi tted to the main monitor bracket in multiple monitor and/or 2 doorbell camera systems. Installing method: 1) check mounting height (145cm/160cm). 2) pass doorbell camera and power adapter cable through the rear of t...
5. Doorbell/camera installation the doorbell/camera position should be tested before fi t off to check the camera position in regards to height and angle. It is recommended you make a temporary connection to check your chosen position is a good all round choice for the average visitor. Ensure the ca...
6. Single monitor connecting and diagram valet recommends that valet 8 intercom cable is used in the wiring of its video intercom systems. The valet 8 cable provides the appropriate screened cable for both video and audio signals. Connecting cable to the monitor mounting bracket pcb 1r: +12v power s...
Multiple monitor systems when adding monitor/handsets a new expansion pcb must be fi tted to your main monitor mounting bracket. This new pcb allows the single monitor to become a multiple monitor and doorbell camera distributor. The expansion pcb allows up to 4 monitors and 2 doorbell cameras to be...
8. Multiple monitor system connection and network diagram 9.
9. Operation 1. When the visitor presses the “call” button on the doorbell/camera, the electronic bell in the monitor/s chime. At the same time, the screen/s display the visitors’ image. 2. You can pick up the phone from any monitor and talk with the visitor for 90 seconds. If you do not pick up the...
10. Technical specifications monitor/handset display screen 4 inch b/w crt resolution >300 tv lines scan frequency 15,625hz(h) 50hz(v) power voltage dc 15~18v video input 75 1vp-p ccir standard power consumption standby state 0.5w; working state 15w wiring mode 4 wires polar dimension 185(w) x 230(h...
Notes 12.
