Valex MMiscel Instruction Manual And Safety Instructions - page 11
- 11 -
MAINTENANCE
!
!
WARNING! Before any control or regulation unplug
it from the power outlet.
!
!
WARNING! Do not tamper with or attempt to repair
the power tool.
The duration and the operating cost are also dependent on
a constant and careful maintenance.
Regularly clean and take care of your power tool, you will
guarantee a perfect efficiency and a long duration.
- Remove dust and machining residues with a soft bristle
brush and a rag.
- Do not spray water or wet electric tools, danger of infiltra-
tion inside .
- Do not use flammable cleaning agents or solvents.
- The plastic parts are actions brought by chemicals.
- Pay particular attention to cleaning the switch, louvers
allow the motor to the spindle.
The tool does not require any particular maintenance, internal
as it is lubricated with permanent grease inside the same . A
possible internal audit or the replacement of graphite brushes
should only be performed by an authorized service center.
PROBLEMS, CAUSES AND REMEDIES
PROBLEM
CAUSE
REMEDIES
The power
t o o l d o e s
not start
Power Line di-
sconnected
Check the electrical
supply line
Plug not inserted Insert the plug into
the power outlet and
press the start button
Worned graphite
brushes
Visit an authorized
service center
Electric fault
Visit an authorized
service center
The power
tool vibrates
too much
tightening of the
whip in the spindle
insufficient
clean the spindle and
repeat the tightening
whip
!
!
WARNING! If after performing the actions described
above, the power tool is not working properly or in case
of anomalies other than those mentioned , take it to a ser-
vice center authorized by showing proof of purchase and
requesting spare parts. Always refer to the information
on the label technical data.
STORAGE
Do a deep cleaning of all the tool and accessories (see Main-
tenance). Protect the unpainted parts with a protective oil and
use the original packaging or in the case (if any) to protect it.
Store the machine out of the reach of children in a stable
position and secure. The place should be dry and free from
dust, tempered and protected from direct sunlight .
At the local storage should not have access children and
strangers.
DISPOSAL
To safeguard the environment, proceed according to the
laws of the country where you are. Consult the competent
authorities for more news on this.
When the machine is no longer usable or repairable, hand
it in with the packaging to an official collection point for
recycling. Remove the batteries (if present) and dispose of
them separately.
Electric and electronic waste may contain substances
that are dangerous for the environment and for human health.
For this reason they must never be disposed of together
with domestic waste, but collected separately in specific
collection centres or returned to the retailer when similar
new equipment has been purchased. The illegal disposal
of such equipment may result in prosecution to the full
extent of the law.
WARRANTY
The product is protected by law against non-compliance
with the declared characteristics provided it is used only
in the manner described in the instructions, it has not been
tampered with in any way, it has been stored properly, has
been repaired by authorized and, where applicable, have
been used only original spare parts.
In the case of industrial or professional use or when using
such a guarantee is valid for 12 months.
To issue a claim under warranty you must present proof of
purchase to your dealer or authorized service center.