Valor 530XAN/XAP Installation Instructions Manual - page 29
29
29
Owner’s Information
Setting the fl ame
Use this setting when you want a particular fl ame level. For instance, you want to
watch fl ames burn at their highest level and you don’t mind if the room is too hot.
To raise the fl ame, press and hold the ▲ button until the flame gets to the
desired level. Let go.
To lower the fl ame, press and hold the ▼ button until the fl ame gets to the
desired level. Let go.
The fl ame level will remain just as you set it.
Programming time and temperature
You can set your fi replace to come on before you wake up and turn off after you
leave and then, turn on again just before you come home and turn off after going
to bed.
You can leave it like this for the heating season.
Decide what temperature you want your fi replace to be at. Also, decide what
time you want your fi replace to turn on and off. Finally, decide what time you
want it to come back on and off in the afternoon or evening. For the fi rst few
times you set the timer, it’s handy to write these times down.
Set the temperature (just as you did in the section Setting the temperature.)
Press the TIMER button and hold it until P1
☼ appears and flashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace to turn on in the morning.
Press the TIMER button and hold it until P1
☽ appears and fl ashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fi replace to turn off when you leave.
Press the
TIMER
button and hold it until
P2
☼
appears and fl ashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes)
to set the time at
which you want your fi replace will turn back on in the afternoon.
Press the TIMER button and hold it until P2
☽
appears and fl ashes. Let go.
While fl ashing, push the buttons ▲ (hour) and ▼ (minutes)
to set the time at
which you want your fi replace to turn off in the evening.
That is all you have to do. Your fi replace will give you steady, even heat at the
temperatures and times you set.
Note: If you want to set your fi replace for only one time on and off, set P2
☼
and
P2
☽
for the same times as P1
☽
.
The remote will record the P1
☽ off time for
both P2 times.
To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go
back to manual settings. Press TIMER to go back to your settings.
When your remote control displays BATT, you need to replace the battery with a
new 9 volt alkaline battery—6LR61/MN1604.
1.
2.
1.
2.
3.
4.
5.
6.
7.