Valor 700IN Owner's Manual - page 9
Manual ON/OFF Switch
Wall Switch
(optional)
Remote control
handset
OFF
ON
operating your fi replace.
Handset and Wall Switch:
Press and hold the OFF
button for a second.
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
Manual ON/OFF Switch:
Press the O button.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your fi replace will not turn on when you
don’t want it on.
First, ensure your fi replace is turned off—including
the pilot—and cold BEFORE going ahead.
• You can prevent your fi replace from lighting by
pressing the O button on the manual ON/OFF
switch on the gas valve—see image above.
• Alternately, you can remove all batteries from the
battery box as well as the battery from the handset.
Automatic Shut-Off
(in certain conditions)
Your fi replace’s remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See page 14 in the Remote Control
Operation
section for a description of this feature.
Lighting, Operation and Rating Information
The Lighting, Operation and Rating information is
located on a plate at the right of the fi rebox. To access
the plate, remove the right hand side door, grab the
plate and take it out to read it. There is important
information on both sides of the plate.
Servicing
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance’s serial number can also be quoted. This
number is on the rating plate, which is located at the
right of the fi rebox. The replacement parts are shown
at the end of this manual. Please always quote the part
number and description when requesting spare parts.
Fireplace Control Devices
There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the fi replace
to function. It can be used to shut off the fi replace in
case of emergency—see next sub-section.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 10–15.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the fl ame height—see
1265WSK—Wall Switch Kit.
NOTE:
The remote control in the AUTO mode will
override the wall switch.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi replace cool fi rst before touching it.
Wall Switch
(optional)
Manual On/
Off Switch
Thermostatic Remote
Control
Owner’s Information
!
9
OWNER’S
INFORMATION