Valor 716EHC Installation instructions manual
4005661-02
716 Edgemont Hammered Trim Kit
Use with Valor 700 Models only
The 716 Edgemont Hammerered Trim Kit is intended
to be used with the Backing Plate 717BPB or 719BPB
installed on the Valor heater model 700.
The 716 fi tted with the 717 backing plate can also be
installed with an additional backing plate 710BPB or
714BPB as well as a riser trim 725RT or 793RT to
cover larger cavity opening.
716EH with 717BPB—
3-sided Backing Plate
716EH with 719BPB—
4-sided Backing Plate
© Copyright Miles Industries Ltd., 2016
36-1/4” (922 mm)
1/2”
(13 mm)
1-1/2”
(38 mm)
26-5/8” (677 mm)
36-5/16” (922 mm)
1/2”
(13 mm)
1-1/2”
(38 mm)
29-1/4” (742 mm)
2-5/8” (67 mm)
between bottom of trim
and bottom of appliance
I N S TA L L E R
Leave this manual
with the appliance.
C O N S U M E R
Retain this manual
for future reference.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
DANGER
!
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and shall be
installed for the protection of children and other at-risk
individuals.
L
EGEND
G3.5
Installation Instructions
for 716EHC, EHV, EHOZ, 717BPB and 719BPB kits
Please note the appliance will have to be raised by
2-5/8” when using the 719BPB 4-Sided Backing Plate
as the plate extends below the bottom of appliance.
Mounting of the 716 does not affect clearances or other
specifi cations listed in the heater installation manuals—
see installation manual supplied with the heater for
more information.
!
!