1. DL manuals
  2. Valor
  3. Electric Heater
  4. 801
  5. Installation And Operating Manual

Valor 801 Installation And Operating Manual

Summary of 801

  • Page 1

    Installation and operating guide for electric heaters model 801 with adorn, icon, visage, elegant or ultimate fireslide fronts & model 802 ultimate, cosyflame, fyrside, nebula & pizzazz versions 600b599/06 this guide is intended to help you install and care for your valor electric heater. Please rea...

  • Page 2

    2 customer care thank you for choosing valor all valor heaters are designed to meet the most stringent quality, performance and safety requirements to provide our customers with many years of trouble free service. This guide aims to improve your understanding and appreciation of your new valor heate...

  • Page 3

    3 general appliance dimensions model projection into cavity (mm) projection into room (mm) overall depth (mm) width (mm) height (mm) 801 adorn 68 153 221 545 768 801 icon 68 59 127 631 622 801 visage 68 89 157 529 611 801 elegant 68 89 157 529 611 801 ultimate fireslide 68 89 157 475 600 802 ultimat...

  • Page 4

    4 figure 4 figure 3 figure 2 figure 1 installation the heater must be fixed into position to prevent it from being tipped over. The following fixing options are available. The parts required for both fixing options are included with all appliances. Screw fixing wire fixing the heater must not be loc...

  • Page 5

    5 figure 5 method d – with 75mm wall spacer kit (supplied with model 802 fyrside, optional extra with other appliances) the wall kit should be securely fixed to the wall using the screws provided. The heater must then be fixed to the wall kit. (see following section –wall spacer kit installation) if...

  • Page 6

    6 figure 9 figure 6 figure 7 figure 8 figure 10 (shown with elegant front) assembly of fronts icon & adorn fronts remove the tape securing the control linkage to the front. Do not lift the front surround by the control knob all models carefully lift the front surround. Hook the front surround onto t...

  • Page 7

    7 important before continuing any further with the installation or using the fire for the first time, please check that the flame effect drum is correctly positioned, as this can sometimes become dislodged during transit. To do this: • lift out the fuel bed. • you will then see the two light bulbs w...

  • Page 8

    8 the slider control there are four slider positions n off fuel effect lighting on fan coolblow on. Fuel effect lighting on (set thermostat at high). Fan heater on (2kw). Fuel effect lighting on (set thermostat to a high setting and allow the room temperature to settle before re-adjusting)..

  • Page 9

    9 figure 13 maintaining your fire always disconnect the heater from the electricity supply by removing the 3 pin plug and allowing the heater to cool before undertaking maintenance or replacing lamps. Lamp replacement the lamps fitted to this heater are long life types, but due to the indeterminate ...

  • Page 10

    10 useful telephone numbers • your post code • type of fire • model / name • serial number • the fault, problem or request general advice about your heater valor advice line 08457 626 341 to report faults or arrange for your heater to be serviced valor service 0121 386 6203 to order spares or for sa...