Valor 855 Dimension Installer And Owner Manual - page 14
5. Insert two wall plugs provided into the holes.
6. Insert a woodscrew into each hole and screw in until there is approximately 6mm of
screw protruding from the wall.
Preparing the heater for installation.
1. Secure the spacer frames to the heater using four
No.8 x 3/8 screws supplied (See figure 12).
Fitting the heater.
1. Carefully lift the heater and locate the slots on the
rear of the spacer frame onto the screws in the wall.
The screws can be adjusted to ensure a tight fit. When
mounting to decorative surfaces such as wallpaper be
careful not to drag the heater down the wall as this may
damage the decorative surface.
Method D - Securing with the clamp.
This method of securing cannot be used in conjunction
with the optional spacer frame. This is an alternative
securing method where fixing to a surround or rear wall
proves impractical.
1. Locate the clamp as in point 1 of figure 13. Place the screw through the upper
bracket on the heater and locate into the clamp - point 2 of figure 13. It is only
necessary to locate the screw, do not continue to turn it as this will elevate the clamp.
2. Place the heater into the surround / opening.
3. Rotate the clamp
screw clockwise
until the heater is
secured in the
surround / opening.
Where applicable,
do not over-tighten
the screw as this
may deform or
cause damage to
the surround /
back panel.
INSTALLER AND OWNER GUIDE
Page 14
©
GDC Group Ltd. 2011
Figure 13.
Figure 12. Fitting the
spacer frame to the heater.