Installer’s and owner’s guide for electric heater model 802 we trust that this guide gives sufficient details to enable the appliance to be installed and maintained satisfactorily. However, if further information is required, our valor technical helpline will be pleased to help. Please telephone 087...
Installer’s and owner’s guide page 2 customer care all our heaters are designed to meet the most stringent quality, performance and safety requirements to provide our customers with many years of trouble free service. This guide aims to improve your understanding and appreciation of your new heater,...
Installer’s and owner’s guide page 3 figure 1. Appliance dimensions installation location this heater is intended for use in a fireplace opening generally conforming to british standard 1251 for a nominal 400mm (16 inch) or 450mm (18 inch) fireplace. It may also be located in other fireplace opening...
Installer’s and owner’s guide page 4 the heater must not be located under a fixed electrical socket, the socket must always be accessible in order to disconnect the heater from the electrical supply for maintenance or when replacing a lamp. • important! This appliance must be earthed. • this heater ...
Installer’s and owner’s guide page 5 figure 2. Figure 3. The heater body should be fixed in position before the front surround is finally fitted. Please study the illustrations carefully to avoid damage to the heater. Front removal carefully remove the front surround by lifting upward and forward (s...
Installer’s and owner’s guide page 6 figure 5. Figure 4. Method b – wire fix the fixing kit includes a steel wire and eyebolt to attach the heater to the back of the fireplace opening. Mark the position for the eyebolt at the back of the fireplace opening equal to the centre line of the heater and a...
Installer’s and owner’s guide page 7 figure 6. Fitting the front carefully locate the bottom sides of the front surround into the side brackets on the heater body. Holding the top of the surround push it towards the top of the heater body. The top of the surround should locate over the top central b...
Installer’s and owner’s guide page 8 operating your heater never cover the heater - there is a risk of fire if covered. The heater is operated by three switches located below the canopy. Switch 1 = o main on – off in the on position only the fuel effect light operates switch 2 = ❙ 1 kw fan heat sett...
Installer’s and owner’s guide page 9 maintaining your fire always disconnect the heater from the electricity supply by removing the 3 pin plug and allowing the heater to cool before undertaking maintenance or replacing lamps. Lamp replacement the lamps fitted to this heater are long life types, but ...
Installer’s and owner’s guide page 10 valor technical helpline if you require any further assistance please call the valor technical helpline on 08706 061 065 to help us quickly help you, please try to have the following information available before you contact us. Your post code type of fire model ...
