Valor BR419 Owner's Manual - page 7
7
FUEL BED REFITTING
If the fuel bed components are dislodged or removed, they must be refitted as follows:
Only the fuel bed parts supplied with this appliance or authorised Valor replacements must be
used. Never add extra coals above the number stated in these instructions.
1
.
With its feather
edge at the top,
place the ceramic
rear wall into the
channel at the back
of the fire box. Push
the wall flat against
the rear of the fire
box. (See figure 4).
2
.
Place the two
halves of the front
base coal in the
burner
compartment so
that they rest on
the ledges at the
sides and front.
Pull the coals
forward so that
they are
immediately
behind the front
rim of the burner
compartment
(See fig. 5).
3
.
Place the rear
base coal in the
burner compartment
behind the front coal.
Its rear face should
touch the rear
ceramic wall (See
figure 6).
4
.
The ceramic side
walls are marked at
the rear bottom
corners “L” (Left side)
& “R” (Right side).
Place the side walls
against the sides of
the fire box and in
the recesses at the
sides of the base
coals. The markings
“L” & “R” should be at
the back bottom
corners and facing to
the centre of the
back of the firebox
(See figure 7).
5
.
Install the 5
loose coals as
follows. The
smooth surfaces
of the coals
should be at the
bottom and back.
5.1
Select the
two largest coals.
Place them in the
central two
valleys of the
front coal (See
figure 8).
5.2
Place the
three remaining
coals behind and
approximately
midway between
each of the coals in
the front row (See
figure 9).
Fig 9 Middle row of
coals
Fig. 8 Front row inner
coals
Fig. 6 Rear base coal
installation
Fig. 5 Front coal
installation
Fig. 4 Ceramic rear wall
installation
Fig. 7 Ceramic side walls
installation