Valor Churchill Installer's Manual - Installer’S Guide
INSTALLER’S GUIDE
Page 26
15.4.6
Remove the burner(s) by unscrewing one screw at the left side and lifting
clear.
15.4.7
The main and decorative flame burners are of different lengths. They cannot
be fitted in the wrong positions.
15.5 To Remove Injectors(s)
15.5.1
Remove the outer case as 15.1 above.
15.5.2
Release the pipe compression fitting(s) to the injector(s).
15.5.3
Loosen the pipe compression fitting(s) to the tap and move the pipe(s) clear.
15.5.4
Remove the injector(s) and carrier(s) from the firebox side.
15.5.5
Remove the injector(s) from the carrier(s)
15.6 To Remove Thermocouple
15.6.1
Remove the outer case as 15.1 above.
15.6.2
Disconnect the thermocouple at the gas tap end.
15.6.3
Undo the nut securing the thermocouple to the pilot unit bracket outside the
firebox side. Withdraw the thermocouple.
15.7 To Remove Electrode Pin
15.7.1
Remove the outer case as 15.1 above.
15.7.2
Disconnect the electrode lead at the pilot unit end.
15.7.3
To gain access to the electrode nut, disconnect the thermocouple at the pilot
unit end as 15.6.3 above.
15.7.4
Undo the nut securing the electrode ceramic and pin to the pilot unit bracket.
15.8 To Remove Pilot Pipe & Jet
15.8.1
Remove the outer case as 15.1 above
15.8.2
Unless the appliance is sufficiently high above the floor to allow access from
underneath, remove the thermocouple and electrode pin from the pilot bracket
as 15.7.3 and 15.7.4 above.
15.8.3
Release the pilot pipe from the gas tap.
15.8.4
Unscrew the pilot pipe from the pilot bracket.
15.8.5
Carefully withdraw the pilot pipe from the pilot bracket - when withdrawing,
the pilot jet will be pulled out.
15.8.6
When replacing, make sure that the pilot jet is hooked over the seating at the
end of the pipe.
15.9 To Remove The Gas Tap And Piezo Unit
15.9.1
Remove the outer case as 15.1 above.
15.9.2
Remove the window unit as 15.2 above.
15.9.3
Remove the ceramic items as 15.3 above.
15.9.4
Remove the burner front cover by unscrewing 14 screws.