Valor equinox 754 Owner's Manual - page 13
7. There are four pebbles
numbered ‘1’ on the underside.
Locate these onto the pebble
base at the ends of the outer
left and right hand ceramic
support rods (See figure 11).
Leave a gap between pebble
‘3’ and the pebble ‘1’ as
shown in figure 11. This will
allow the pilot flame to be
viewed.
8. There are two pebbles
numbered ‘2’ on the
underside. Locate these on
the pebble base between the
ends of the inner left and
right ceramic support rods
(See figure 12).
Important note: The gap
between the number ‘2’
pebbles affects the final
flame picture. If the flames
tend to the sides of the fuel
bed then increase the gap
between the number ‘2’
pebbles. If the flames tend
to the centre of the fuel bed
then decrease the gap
between the number ‘2’
pebbles. The amount of
movement may be as little
as 3 – 5mm.
9. There are seven pebbles lettered ‘A’ to ‘D’ on the underside. Locate these evenly over
the top of the first layer of pebbles (See figure 13). To optimise the flame picture it may
be necessary to position these pebbles away from the centre of the fuel bed allowing
more central flames.
Page 13
OWNER GUIDE
Figure 13. Pebbles lettered ‘A’ to ‘D’ location
Figure 12. Pebble number ‘2’ location
Figure 11 Pebble number ‘1’ location