Valor Firelite OXYSAFE 2 Owner's manual

Manual is about: RADIANT/CONVECTOR GAS FIRES

Summary of Firelite OXYSAFE 2

  • Page 1

    600b691/08 owner’s guide this appliance is for use with natural gas (g20) this appliance is for use in the united kingdom (gb) and the republic of ireland (ie) only. This guide is intended to help you care for your valor gas fire. Please read thoroughly before using and keep for future reference we ...

  • Page 2: Owner’S Guide

    Owner’s guide page 2 safety first. Valor fires are ce approved and designed to meet the appropriate british standards and safety marks. Quality and excellence at the heart of every valor fire. All valor fires are manufactured to the highest standards of quality and excellence and are manufactured un...

  • Page 3: Owner’S Guide

    Owner’s guide page 3 list of contents safety ..............................................................................................................................3 appliance dimensions............................................................................................6 operating you...

  • Page 4: Owner’S Guide

    Owner’s guide page 4 graph 1 shelf clearances do • have the fire installed by a competent person. In the united kingdom, installation must be in accordance with the latest edition of the gas safety (installation & use) regulations. In the republic of ireland, installation must be in accordance with ...

  • Page 5: Owner’S Guide

    Owner’s guide page 5 do • wait three minutes before attempting to relight if the fire is switched off or the flames are extinguished for any reason. (your fire is fitted with a safety device that will automatically shut off the gas supply to the fire if, for any reason, the flames go out.) • get adv...

  • Page 6: Owner’S Guide

    Owner’s guide page 6 figure 1. Dimensions & clearances appliance dimensions.

  • Page 7: Owner’S Guide

    Owner’s guide page 7 figure 3. Pilot flame viewing (shown with firelite case) figure 2. Control operating your fire please note when operating your fire for the first time, some vapours may be given off which may cause a slight odour and could possibly set off any smoke alarms in the immediate vicin...

  • Page 8: Owner’S Guide

    Owner’s guide page 8 in the unlikely event of failure of the ignition mechanism the pilot can be lit with a long match or taper – see the next page. • when the pilot has lit keep the knob depressed for about ten seconds to allow the flame sensing probe to warm up. • the control knob can then be set ...

  • Page 9: Owner’S Guide

    Owner’s guide page 9 figure 4. Replacing radiant (shown with firelite case) cleaning turn the fire off and allow it to cool before attempting any cleaning. Normally the fire will only need dusting. The bright metal trims may be cleaned with a damp cloth and dried with a soft duster. Obstinate marks ...

  • Page 10: Owner’S Guide

    Owner’s guide page 10 • replace the dress guard. Locate the bottom of the dress guard in the two holes in the bottom panel apron. Push the guard back so that the two spring projections at the top of the guard engage in the slots under the front decorative canopy. Maintenance regular maintenance in o...