1. DL manuals
  2. Valor Fires
  3. Indoor Fireplace
  4. 824 Blenheim Longlite
  5. Installer And Owner Manual

Valor Fires 824 Blenheim Longlite Installer And Owner Manual

Other manuals for 824 Blenheim Longlite: Installer And Owner Manual

Summary of 824 Blenheim Longlite

  • Page 1

    © baxi heating u.K. Limited 2010. 5137668-04 important: please keep your guide in a safe place for future reference. Installer and owner guide this guide is intended to help you install and care for your valor fires electric firefront. Please read carefully before installing and using your heater. H...

  • Page 2

    Baxi heating u.K. Limited 2010. All rights reserved. No part of this publication may be reproduced in any material form (including photocopying), stored in any medium by electronic means (including in any retrieval system or database) or transmitted, in any form or by any means, whether electronic, ...

  • Page 3

    Page 3 installer guide © baxi heating u.K. Limited 2010. Installer guide for owner guide see pages 18 to 31.

  • Page 4: Contents

    Contents section heading page installer guide 3 - 17 owner guide 18 - 31 1. Image 5 2. Handling and unpacking 6 3. Safety 7 4. Optional spacer frame kit 8 5. Pack contents 9 6. Fitting the firefront 10 general notes to read before fitting your firefront. 10 do i need any tools? 10 where can i fit th...

  • Page 5: 1. Image

    1. Image page 5 installer guide © baxi heating u.K. Limited 2010..

  • Page 6: 2. Handling And Unpacking

    2. Handling and unpacking before continuing any further with the installation of this firefront please read the following: important safety instructions. The approximate weight (kg) of the firefront parts are listed below: model heat engine firefront fascia spacer* top coal blenheim 5.9 3.8 1.0 1.3 ...

  • Page 7: 3. Safety

    3. Safety this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety...

  • Page 8

    Caution: in order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. Important! This firefront must be earthe...

  • Page 9: 5. Pack Contents

    5. Pack contents installer guide figure 2. Contents. Fascia and coals not shown (items are not to scale) contents quantity (illustrations are not to scale) firefront (design may differ from that shown) 1 spacer frame 1 only no. 8 x 3/8 pan head screw 4 tension wire 1 diffuser 1 boiler control and co...

  • Page 10: 6. Fitting The Firefront

    6. Fitting the firefront general notes to read before fitting your firefront. The installation of this firefront requires a reasonable level of diy skills. Please read this guide thoroughly before commencing installation and if in doubt, seek help from a competent person. Important: before continuin...

  • Page 11

    Removing the cable guide. 1. Before removing the cable guide please note that the wider part of the cable guide is on the outer edge of the base (see figure 3 - item 1). 2. To remove the cable guide push and lift the tab on the bottom. The bottom of the cable guide will open (see figure 3 - item 2)....

  • Page 12

    Fitting the control knob. The control knob is supplied separately with the accessory pack. Fit the control knob before continuing with the firefront installation. To assemble the control knob to the control spindle, firstly line up the ‘d’ profile on the underside of the control knob to the ‘d’ prof...

  • Page 13

    Securing the firefront. All fixings supplied with the firefront have been identified in figure 2. The firefront must be secured into position to prevent it from being tipped over. The following securing options are available: method a - securing with wire. Method b - securing with wire using an opti...

  • Page 14

    5. At the top of the firefront there are four small holes, two each side of the firefront. From the front of the firefront, thread about 50mm of the wire into the outside small hole on the right side of the firefront (see point 1 - figure 8). 6. Thread the other end of the wire through the remaining...

  • Page 15

    Method b - securing with wire using an optional spacer frame kit (see section 3). Although the firefront is supplied with a 50mm deep spacer frame, an optional 50mm deep spacer frame kit is obtainable either from your firefront supplier or direct from valor fires sales. The spacer kit is an addition...

  • Page 16

    Fitting the light diffuser. 1. There is a light diffuser supplied with the firefront (see figure 10). Place this on to the metal flange below the plastic screen. Fitting the fascia. 1. The magnets may have moved in transit. Locate the magnets as in figure 11. 2. Fit the fascia to the firefront by ho...

  • Page 17

    7. Removing the fascia and firefront to gain access to the boiler for servicing and maintenance it will be necessary to remove the firefront. Do this as below: 1. Unscrew the ash pan knob and remove the hearth casting from beneath the fascia. 2. Firmly hold the lower sides of the firefront fascia an...

  • Page 18

    Page 18 owner guide © baxi heating u.K. Limited 2010. Owner guide for warranty and service information see pages 27 to 31.

  • Page 19: Contents

    Contents section heading page 1. Image 20 2. Safety 20 3. Operating the firefront 22 important safety. 22 what are the fireslide control positions for? 22 what is the variable energy control knob for? 22 4. Operating the boiler 23 understanding the boiler control functions. 23 is the boiler on or of...

  • Page 20: 1. Image

    1. Image 2. Safety © baxi heating u.K. Limited 2010. Owner guide page 20 warning! If you smell gas.  do not operate light switches.  do not operate any electrical equipment.  do not use a telephone in the hazardous area.  extinguish any naked flame and do not smoke.  open windows and doors in t...

  • Page 21

    This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children...

  • Page 22: 3. Operating The Firefront

    3. Operating the firefront important safety. Never cover the firefront or obstruct the openings at the base of the firefront, this could cause overheating and consequent risk of fire. What are the fireslide control positions for? The firefront is operated by the fireslide control located on the uppe...

  • Page 23: 4. Operating The Boiler

    4. Operating the boiler the boiler control is located on the upper right hand side of the firefront (see figure 3). Note: to operate the boiler control the on / off button needs to be pressed for a minimum of half a second. Understanding the boiler control functions. Is the boiler on or off? If the ...

  • Page 24

    How do you know when the system external controls are requesting heating or hot water ? (when switched on the boiler will be operated by a separate control. This may be a timer or room thermostat control). 1. When the boiler is on and heat is required a vertical bar will appear in the top left of th...

  • Page 25

    Lockout / error codes. The following codes are user resettable. E110 – high limit thermostat or safety float switch operation. E125 – boiler maximum water temperature exceeded twice in 2 hour period. E131 – burner lockout after power off/on during the fault e125. E133 – burner lockout due to no flam...

  • Page 26

    5. Cleaning and maintaining the firefront how do i clean my firefront? The firefront fascia and plastic parts need only to be wiped clean with a dry soft cloth, do not use polishes or abrasive materials. I have a problem with my firefront! Important safety before undertaking maintenance always disco...

  • Page 27: 6. Environment

    6. Environment environmental protection. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. What should i do when i’m ready to dispose of my firefront? The plug should be r...

  • Page 28

    When calling heateam, it would be helpful if you could have the following information to hand:- 1. Firefront serial number.* 2. Firefront brand and model number.* 3. Date of installation.* 4. Proof of purchase (if you do not have the firefront serial number) *note: details 1 – 3 can be found on the ...

  • Page 29

    Page 29 © baxi heating u.K. Limited 2010. Owner guide.

  • Page 30: Installer Details

    Page 30 © baxi heating u.K. Limited 2010. All areas to be completed by the installer: installer details owner guide installer name gas safe register or corgi registration number. Company name. Company address company telephone number company fax number boiler details d d m m y y date of installation...

  • Page 31: Firefront Details

    Page 31 © baxi heating u.K. Limited 2010. Owner guide firefront details model 8 2 4 serial number (can be found on the information label - see figure 5) fascia name (block capitals) a label containing the serial number may have been placed inside this box. Firefront serial number label to be affixed...

  • Page 32

    © baxi heating u.K. Limited 2010..