1. DL manuals
  2. Valor Fires
  3. Heater
  4. 842
  5. Installer And Owner Manual

Valor Fires 842 Installer And Owner Manual - Securing The Heater.

Manual is about: ELECTRIC HEATER

Summary of 842

  • Page 1

    5132650 / 01 © baxi heating u.K. Limited 2008. Model 842 electric heater fitted with a nano fascia. (gc no. Ef-032-32) important: please keep your guide in a safe place for future reference. Installer and owner guide this guide is intended to help you install and care for your valor fires electric h...

  • Page 2: Plumbnation.Co.Uk

    The nation’s favourite for plumbing & heating supplies secure payments shop online with confidence free shipping on all orders over £100 to mainland uk finance available spread the cost with low interest rates price match always get the best deals available boilers radiators heating controls pipes &...

  • Page 3

    © baxi heating u.K. Limited 2008. All rights reserved. No part of this publication may be reproduced in any material form (including photocopying), stored in any medium by electronic means (including in any retrieval system or database) or transmitted, in any form or by any means, whether electronic...

  • Page 4: Customer Care

    Safety first. Valor fires heaters are ce approved and designed to meet the appropriate british standard s and safety marks. Quality and excellence. All valor fires heaters are manufactured to the highest standards of quality and excellence and are manufactured under a bs en iso 9001 quality system a...

  • Page 5: 1. Handling And Unpacking

    1. Handling and unpacking before continuing any further with the installation of this heater please read the following: important instructions. A carry handle is fitted to the top of the heater. We recommend that this is used when moving the heater. The approximate lifting weights (kg) of the heater...

  • Page 6

    Always always install the heater in accordance with this guide. If in doubt obtain expert advice. Always make sure the electrical socket is accessible and located adjacent to, but not above or behind the heater. Always disconnect the heater from the electrical supply before carrying out cleaning, ma...

  • Page 7: 3. Optional Kits

    3. Optional kits the following kits are obtainable either from your heater supplier or direct from valor fires sales. Spacer frame kit 0584081 elevated installation kit 0584091 page 6 installer and owner guide © baxi heating u.K. Limited 2008. Contents quantity (illustrations are not to scale) space...

  • Page 8: 4. Fitting The Heater

    4. Fitting the heater before continuing any further with the installion of the heater please fill in the details on the last page of this guide. Important: before continuing with the installation of this heater please ensure that you have completed the information on the last page of this guide. Ple...

  • Page 9: Your Heater.

    Q do you want to fit the heater against a flat wall with the base of the heater on a hearth or similar surface? A you will need to purchase the optional spacer frame kit (kit number 0584081). This spacer when added to the one supplied with the heater enables the heater to be flat wall fixed. The dep...

  • Page 10

    Heater it is important to check that the lamp has not become loose in transit. The lamp is located into a cradle on the rear of the access panel. Open the access panel by unscrewing the locking screw in an anticlockwise direction. Ensure that the lamp is located firmly in the lamp holder (see figure...

  • Page 11: Securing The Heater.

    Securing the heater. The contents have been identified in figure 4 (fascias are not included). Page 10 installer and owner guide © baxi heating u.K. Limited 2008. Contents quantity (illustrations are not to scale) heater 1 spacer frame 1 spare lamp 1 no. 8 x 3/8 pan head screw 5 tension wire 1 screw...

  • Page 12

    The heater must be secured into position to prevent it from being tipped over. The following securing options are available: method a - securing the heater with screws. Method b - securing the heater with wire. Method c - securing the heater using the spacer frame supplied with the heater. Method d ...

  • Page 13

    Method b - securing with wire. This method of securing is recommended where the wall / brickwork is in poor condition or where marble back panels / surrounds are used. Although this section deals with fireplace openings without a spacer, this method of securing the heater can also be used with the s...

  • Page 14

    Small hole on the left hand side of the heater (see figure 7). 11. Locate the heater in the fireplace opening, then from the front of the heater, gently pull the steel wire on the right hand side to gather up the excess until the heater is secure. Thread the wire through the remaining small hole to ...

  • Page 15: 0584081

    Method d - securing with the optional spacer frame supplied in kit 0584081 . The optional spacer is for use where a flat wall installation is required. 1. There are four screws supplied with the optional spacer frame. The narrow flange of the optional spacer should be placed against the spacer suppl...

  • Page 16: 0584081)

    Method e - wall mounting with the optional spacer frame kit ( 0584081) and elevated installation kit supplied in kit ( 0584091) . The optional spacer frame and elevated installation kit are required where a wall mounted installation is required. (the nano fascia has been designed for traditional ins...

  • Page 17

    Fitting the brackets to the heater. 1. Secure the spacer frames to the heater as in steps 1 and 7 of method d (see figure 10). 2. The elevated installation kit contains two wall mounting brackets and one lower bracket. Secure one of the wall mounting brackets to the rear of the heater using two of t...

  • Page 18: 5. Fitting The Fascia

    5. Fitting the fascia important: before fitting the fascia ensure that you have completed the information on the last page of this guide. Fitting the fascia. 1. Remove the fascia from its packaging. 2. There are three magnets on the fascia (see figure 14). Ensure that they are located correctly befo...

  • Page 19: Important Safety.

    7. Cleaning and maintaining the heater important safety. Before undertaking maintenance or replacing the lamp always disconnect the heater from the electricity supply by removing the 3 pin plug and allowing the heater to cool. How do i clean my heater? The heater and plastic parts need only to be wi...

  • Page 20

    Replace the lamp and close the access panel. When handling the lamp avoid touching the glass with bare fingers as this will reduce the life of the lamp. Be careful not to trap wiring between the access panel and heater body. It is important when buying replacement lamps to ensure that the filament i...

  • Page 21: 8. Environment

    For spares inquiries spare parts are available nationwide via the ‘interpart stockist network’. For your local stockist consult yellow pages under ‘central heating’. When ordering spare parts please have the below information available. This will help us to deal with your call quicker and avoid you ...

  • Page 22: 9. Warranty And Service

    9. Warranty and service information for the customer standard warranty terms & conditions the warranty is for 12 months subject to contract. In the united kingdom servicing can be carried out either by a heateam service engineer or a suitably qualified person. You must register your heater with heat...

  • Page 23

    What this warranty does not cover repairs to heaters which haven’t been installed properly and as set out in this guide. Faults caused by inadequate supply of electricity. Reimbursement of any third party repair or replacement costs that we haven’t been told about or agreed with you in advance. Comp...

  • Page 24

    To be completed by the customer: page 23 installer and owner guide © baxi heating u.K. Limited 2008. Brand (please tick) baxi valor wonderfire other........................ D d m m y y date of installation a label containing the fascia code may have been placed inside this box. Fascia name (block ca...

  • Page 25

    © baxi heating u.K. Limited 2008..