Valor Fires 850 Installer And Owner Manual - page 17
7. OPERATING THE HEATER
Never cover the heater or obstruct the opening at the base of the heater, this
could cause overheating and consequent risk of fire.
The appliance can be controlled by the manual control located
behind the ash pan cover on the lower right hand side of the
heater or by using the remote control handset.
The heat settings are quoted using a 240V ~ 50Hz supply.
Remote Control - What do the buttons do?
Pressing the red ‘ON/OFF’ button.
To activate the remote handset it is necessary to press the red
ON/OFF button. The status lamp on the heater will turn red (see
figure 19).
Pressing the ‘LAMP’ button.
This turns the
effect on. The indicator lamp will
flash green for approximately five seconds, after this time the lamp
will no longer be visible (see figure 19).
Pressing the ‘Heat 1’ button.
This turns the
effect and 675 watt heater on. The indicator lamp will
flash amber for approximately five seconds, after this time the lamp will no longer be
visible.
Pressing the ‘Heat 2’ button.
This turns the
effect and 1350 watt heater on. The indicator lamp will
flash red for approximately five seconds, after this time the lamp will no longer be
visible.
INSTALLER AND OWNER GUIDE
Page 17
©
Baxi Heating U.K. Limited 2010.
Figure 18.
Figure 19. lamp locations