Valor Fires 870 hydroflame Dream Installer And Owner Manual - Securing The Heater.
Securing the heater.
The heater must be secured into position to prevent it from being tipped over.
The following securing options are available:
Method A - Securing the heater with Screws.
Method B - Securing the heater with Wire.
Method C - Securing the heater using the Optional Spacer Frame and Screws
(kit number 5135855).
Method D - Securing the heater using the Optional Spacer Frame and Wire
(kit number 5135855).
Before securing the heater please read point 9 of section 6.
Method A - Securing with screws.
Note - If fixing to marble it is recommended that Method B - ‘Securing with wire’ is
used. Drilling marble without the correct tools and experience may result in the
marble cracking.
1. Place the heater into the fireplace or surround
opening
. Make sure that the heater is in the middle
of the surround or fireplace.
2. There are two slotted holes in the top of the heater
and two in the lower side flanges (See figure 5). We
recommend the use of all four holes. Mark through
the holes so that their position is clear when the
heater is removed.
3. Gently move the heater forward being careful not
to strain the flexible hoses or system pipe work.
4. Drill an appropriate size hole in each of the
marked positions for the wall plugs supplied. Insert
wall plugs into the drilled holes.
5. Connect the heater to the fused spur.
6. Place the heater so that the holes are in line with
the wall plugs in the fixing surface.
7. Screw and secure the heater with four wood
screws - (See figure 1 and 5).
Method B - Securing with wire.
This method of securing is recommended where the wall / brickwork is in poor
condition or where marble back panels / surrounds are used.
Page 12
©
Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
Figure 5. Screw locations