1. DL manuals
  2. Valor
  3. Indoor Fireplace
  4. Legend 736XN
  5. Installer's & Owner's Manual

Valor Legend 736XN Installer's & Owner's Manual

Summary of Legend 736XN

  • Page 1

    Legend model 736xn for use with natural gas model 736xp for use with propane installer’s & owner’s manual installer – please leave this manual with the home owner for your safety do not store or use gasoline or other flammable liquids in the vicinity of this or any other appliance. Warning: improper...

  • Page 2

    2 caution warning: do not operate the appliance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person. (the front frame and glass window may be temporarily removed by the owner for cleaning the interior of the firebox, etc....

  • Page 3

    3 1. Installation instructions 1.1 optional accessories the following kits can be used with this appliance: i. #700zck zero clearance kit – required for use with a new zero clearance type installation (see possible installations section following). Ii. #710cfk circulating fan kit – operated by a var...

  • Page 4

    4 ii. As a zero clearance installation fitted with the optional part #700zck kit, the appliance may be installed into a minimum sized enclosure constructed of combustible building materials and connected to an approved type “b” vent. This kit (complete with full installation details) is available fr...

  • Page 5

    5 1.6 floor the floor in the fireplace recess must be sufficiently flat and level to support the appliance satisfactorily. Some fireplace constructions have a well in the floor at the back, which may need to be filled in. Do not place the appliance on carpeting, vinyl or other soft-surface floor cov...

  • Page 6

    6 2.1.6 check ignition electrode spark pilot ignition is by a spark produced when the control knob is pushed in and turned counterclockwise to the “ign” position. Check that two consecutive sparks are produced at the pilot burner. If there is no spark, check that the wiring is secure. Replace parts ...

  • Page 7

    7 2.3.2 #678fsk & #679fsk 2 1 / 2 ” contoured trims 1. Assemble the left and right side channels to the top channel using the inner and outer corner fixing brackets and 12 thread cutting screws provided. See figure 13. 2. Attach the trims to the front frame with 4 thread cutting screws provided. See...

  • Page 8

    8 4.3 leak testing all piping and connections must be tested for leaks after installation or servicing. All leaks must be corrected immediately. When testing for leaks: 1. Make sure that the appliance control knob is at the off position. 2. Open the manual shut-off valve. 3. Test for leaks by applyi...

  • Page 9

    9 7. Refit the window 1. Hook the top of the window frame over the firebox top front edge. 2. Secure the window unit in place by refitting two knurled screws at the bottom corners of the frame. 8. Check operation of controls check ignition, valve control and thermostat settings as described in the l...

  • Page 10

    10 11. Aeration adjustment both front and rear burners are equipped with adjustable shutters to control primary aeration. The air holes are at the right side of the front and rear burner rails - see figure 24. The appliance is supplied with the air holes of both burners fully open. The shutters can ...

  • Page 11

    11 for your safety read before lighting warning: if you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions e...

  • Page 12

    12 16. Cleaning all cleaning should be carried out when the appliance is cold. Normally the appliance should only need dusting. Dust etc. Can be brushed from the logs using a soft brush after detaching the inner front unit and window – see installation instructions sections 2.1.2 and 2.1.3. Dust etc...

  • Page 13

    13 figure 27. Burner module removal.

  • Page 14

    Manufactured by heating birmingham, england because our policy is one of constant development and improvement, details may vary slightly from those given in this publication. © valor ltd. 1999, 2000