Valor quantum 746 Owner's Manual - Cleaning
and turn clockwise to the “Off” position.
Wait at least three minutes before
relighting.
Lighting with a taper
See figure 3.
In the unlikely event of failure of the ignition
spark, the pilot can be lit by a taper or long spill.
Insert the taper or spill through the lower left
hand opening in the front of the fuel effect bed.
Follow the section ‘ Lighting the pilot’ as
described previously.
CLEANING
To maintain the high performance and quality finish of your Valor appliance, please
follow these guidelines:
Before attempting to clean the fire, please remember to turn off the fire and wait for
the appliance to cool. The fire will retain heat for some time before cleaning can begin.
If any pieces of debris are found in the firebox, have the chimney inspected before
further use.
Metal Parts
Clean the metal parts with a slightly damp cloth and then dry.
Do not use abrasive cleaners as these will scratch the fire surface.
Front surround -Clean the metal parts with a slightly damp cloth and then dry. If
this does not work apply a very small amount of ‘baby oil’ to a lint free, non-abrasive
cloth and wipe over the surface. Use a clean cloth to wipe off the oil.
Ceramic fuel effect and Rear Wall
This product uses fuel effect pieces and burner compartment rear wall
containing Refractory Ceramic Fibres (RCF), which are man-made vitreous
silicate fibres. Excessive exposure to this material may cause irritation to eyes, skin
and respiratory tract. Consequently, it is important to take care when handling
these articles to ensure that the release of dust is kept to a minimum.
Light coatings of soot will usually be burnt off during the normal operation of the
fire.
Should any soot accumulation become excessive, the fuel effect pieces and walls
Page 9
OWNER GUIDE
Figure 3. Lighting with a taper
(Shown with Quantum surround)