Valor RetroFire RF24DN Installation And Owner's Manual - page 17
17
Remote Control Installation
1. Connect the wiring harness to the receiver box, by
pushing the wire connector on to the receiver circuit
board. The plug will only go on one way so please
ensure that the wires are pointing up and slot in the
board is in line with the tab on the wiring harness
plug.
2. Connect wires as shown. Please note that the “L”
connectors are different sizes, the smaller one fits
to the lower connection and the larger one the top
connection on the top left hand side of the valve.
The other two wire connectors can be fitted to either
terminal located to the left of the flame control
button.
3. Remove the remote control receiver lid.
4. Fit four AA 1.5 V alkaline batteries.
5. Place the remote control receiver on the base of
the fireplace beside the valve.
6. Fit the 9 V alkaline battery to the handset
transmitter.
Remote control operating instructions are on
pages 20–21 of this manual.
Remote Receiver
Receiver
GV34 Valve
Push-on
Connector
Window Refitting and Checking
Hook the window over the top edge of the firebox, and
fasten the bottom two spring loaded bolts by pushing
in and turning 90 degrees. Check that the window
moves freely against the spring by pulling out at the
bottom. If broken, the window may only be replaced as
a complete unit as supplied by the manufacturer.
Note: To remove the window, the cast iron fret and
fret retainers will need to be removed first—see
section
Cast Iron Fret Installation
.
Check that Window
Moves Freely After
Reinstallation
Spring Loaded
Fastening Studs (2)
1/4 Turn
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER until the wires are
connected to the burner control unit as short-
circuit could result in the destruction of the
electrical components.
CAUTION
DO NOT USE
a screwdriver or other metallic object
to remove the batteries from the receiver or the
handset! This could cause a short circuit to the
receiver.