Valor Ridlington 944 Installer And Owner Manual - page 23
Operating the burner.
-
When the pilot burner is operating
properly, gradually turn the control knob
anti-clockwise to 'HIGH' position.
(Depress the knob slightly to get past
the pilot ignition position). The main
burner should now light.
Depress the control knob slightly to
release from the 'HIGH' position and
turn back (clockwise) to 'LOW'. While
turning, the burner flames should
gradually become lower but remain
alight. Depress the control knob slightly
to release from the 'LOW' position and
turn back (clockwise) to the Pilot ignition position. The main burner should extinguish
but the pilot should remain alight. Depress the control knob slightly and turn back
(clockwise) to turn OFF. This will extinguish the pilot.
While cooling, the ceramic fuel effects may make some crackling noises. This is quite
normal.
Note i)
If the flames go out while setting the control, repeat the full lighting
procedure. If the flames repeatedly go out have the stove serviced.
ii)
Please note. When first turned on the flames will appear predominantly
blue. The fuel effect pieces will take time to warm up. Although some glow
will be seen after approximately ten minutes, the full visual effect will only
be apparent after a somewhat longer time.
iii)
The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to its highest setting. This will also burn off any carbon
deposits that may have formed during previous operations.
iv)
If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help to remove any carbon deposits
that may form during operation.
Page 23
©
GDC Group Ltd. 2014
Figure 3.
OWNER GUIDE