Valor Senator 276N Installation And Operation Manual - page 13
13
3) Remove the two screws securing the upper corners of the
mesh guard (figure 15).
4) slide the guard up and remove it from the heater.
5) Remove dust and loose particles from the log and burner
using a vacuum cleaner
.
6) Replace the guard and mantle. Make sure the guard is
replaced the correct way up. If it is fitted upside down, the
mesh will considerably reduce the visibility of the burner
flames (See figure 16).
7) If the heater still does not operate correctly, get exert advice.
SERVICING
This appliance should have a regular 12 monthly inspection and
service. The inspection should include
• Checking burner rail aeration inlets , gas inlet and exit
orifices.
• Checking pilot orifice, thermocouple tip condition and pilot
unit performance.
• Checking for any log degradation.
Repair and replacement work should only be undertaken by a
qualified service person.
Please always quote Appliance model and serial number when
requesting work.
REPLACEMENT PARTS
Contact your dealer for replacement parts.
If you are unable to obtain the part from your dealer, contact:-
GASM,
Post Office Box 604
Portland, TN 37148
Phone (Toll free): 1-800-892-8136
Fax (Toll free): 1-800-872-8062
Please always quote Appliance model and serial number on all
communications.
Refer to the separate repair parts list supplied with this heater for
repair parts.
NOTES FOR SERVICE ENGINEER
1.
If the thermostat is removed and refitted or replaced, make
sure that there is an air space between the inner side of the
thermostat block and the fire box channel plate. This
space is maintained either by the screwed bushes
projecting through the channel plate or by star washers
spacing the thermostat away from the plate. The air space
is required to keep the thermostat block temperature
within its safe working limit. If star washers were fitted,
make sure that they are replaced. Don’t use solid washers.
Star washers are used to minimize the heat transfer area.
2.
If the mesh guard is removed, make sure it is replaced the
correct way up. If it is fitted upside down, the mesh will
considerably reduce the visibility of the burner flames (See
figure 16).
3.
The top surface of the stainless steel channel below the
mesh grill will color with use. This is quite normal. The
channel will not need to be changed. The channel surface
is only visible when the cast-iron mantle is removed.
Figure 15 Mesh guard screws
Figure 16 Mesh guard - Checking for correct way up