1. DL manuals
  2. Valor
  3. Indoor Fireplace
  4. Sunfire 337
  5. Owner's Manual

Valor Sunfire 337 Owner's Manual

Summary of Sunfire 337

  • Page 1

    5109300/01 owner guide this guide is intended to help you care for your gas fire. Please read thoroughly before using and keep for future reference this guide to be left with the owner © valor heating this appliance is for use with natural gas (g20) this appliance is for use in the united kingdom (g...

  • Page 2

    Safety first. This gas fire is ce approved and designed to meet the appropriate british standards and safety marks. Quality and excellence at the heart of every valor fire. This fire has been manufactured to the highest standards of quality and excellence and are manufactured under a bs en iso 9001 ...

  • Page 3: List of Contents

    List of contents safety................................................................................................................3 appliance dimensions................................................................................ 6 operating your fire ...........................................

  • Page 4

    Do have the fire installed by a competent person. In the united kingdom, installation must be in accordance with the latest edition of the gas safety (installation & use) regulations. In the republic of ireland, installation must be in accordance with all national and local regulations in force. Hav...

  • Page 5

    Do wait three minutes before attempting to relight if the fire is switched off or the flames are extinguished for any reason. (your fire is fitted with a safety device that will automatically shut off the gas supply to the fire if, for any reason, the flames go out.) get advice about the suitability...

  • Page 6: Appliance Dimensions

    Appliance dimensions page 6 owner guide figure 1 dimensions & clearances.

  • Page 7: Operating Your Fire

    Operating your fire the oxysafe flame sensing & flue blockage safety system. For your safety, this appliance is fitted with a flue blockage safety device that will shut down the appliance in the event of abnormal flue conditions. This device is not a substitute for an independently mounted carbon mo...

  • Page 8

    To off and try again. In the unlikely event of failure of the ignition mechanism the pilot can be lit with a long match or taper – see the next page. When the pilot has lit keep the knob depressed for about ten seconds to allow the flame sensing probe to warm up. The control knob can then be set to ...

  • Page 9: Cleaning

    Cleaning turn the fire off and allow it to cool before attempting any cleaning. Normally the fire will only need dusting. The bright metal trims may be cleaned with a damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard and trims using soapy water. Never use abrasiv...

  • Page 10: Maintenance

    Replace the dress guard. Locate the bottom of the dress guard in the two holes in the bottom panel apron. Push the guard back so that the two spring projections at the top of the guard engage in the slots under the front decorative canopy. Maintenance regular maintenance in order to achieve and main...