Valor The Arden Operating & Installation Manual - page 8
8
The Arden Multifuel Stove
INSTALLATION
FIREBOX LINER PANELS
The Arden Multifuel stove use firebox liner panels
to the sides and back. The throat plate sits on top of
the side and rear panels. These should come fitted
to your fire, if however they are not proceed as
follows to fit them.
•Remove the front fuel bars or multifuel grate.
•Set the small liner into the back of the fire.
•Insert side liner panels into each side of the fire.
•Fit the throat plate with the single bend and two
cut outs to the front facing up. The projecting lugs
sit on top of the side liners. The long centre tab on
the back edge rests on the rear liners. The shorter
turn-down tabs against the vertical face.
•Replace the front fuel retainer bars or multifuel
grate.
Note: Neither the rear firebox liners nor the side
firebox liners are "handed", both faces are
suitable for direct contact with the fire.
Note: Cracking of lining panels does not effect
efficiency.
Fig. 1 Liners inserted into the Arden.
Fig. 2 (Inserting Throat Plate)
Fig. 3 Liners, throat plate and grate in
the Arden.
REMOVAL OF THE THROAT PLATE
Blocked chimneys cause dangerous fumes to
escape. Remove throat plate at least monthly to
clean. Keep chimney and flue ways clear.