Value Hobby Elite Model Aviator 75 ARF Instruction Manual - page 14
www.valuehobby.com/aviator-75-arf.html
14
Step19. Slide the elevator and stabilizer together.
The gap between the elevator and stabilizer should
be infinitely small. Make sure the end of the
elevator is aligned with the stabilizer.
Apply thin CA to each hinge. Make sure the hinge is
fully saturated with CA.
Step20. Gently pull on the elevator to ensure the
hinges are secure and cannot be pulled apart.
Move the elevator up and down to break in the
hinges.
Section4. Rudder and Elevator Servo Installation
Step1. Remove the coverings for the elevator and
rudder servo on the fuselage.
Step2. Install the elevator rudder onto the fuselage
using the screws provided with the servo.
Step3. Enlarge the second hole in the control horn
and connect the pushrod to it.
Position the control horn on the elevator. Use the
pushrod wire a guide to align the horn to the EZ
connector.
Position the horn so the holes align so the holes
align with the hinge line. Use a felt-tipped pen to
mark the positions for the mounting bolts.