8mm laser instruction manual specifications wingspan : 800 mm (31.5 in) length : 790 mm (31.1 in) wing area : 14.6sq dm (226.3sq in) flying weight : approx. 250 g (8.5oz).
Www.Valuehobby.Com/8mm-epp-laser.Html 2 dear customer, congratulations on your purchase of laser 8mm epp airplane arf from value hobby. We thank you for your generous support, and hope you enjoy your new airplane. At value hobby, we hope to offer competitive prices, good performance, and products th...
Www.Valuehobby.Com/8mm-epp-laser.Html 3 safety in flying this is not a toy! It is a very high-performance rc airplane capable of high speeds and extreme maneuvers. It should only be operated by a competent pilot in a safe area with proper supervision. Only fly your aircraft in a safe, open area, awa...
Www.Valuehobby.Com/8mm-epp-laser.Html 4 main parts 1. Wings 2. Horizontal fuselage 3. Vertical fuselage 4. Tail 5. Foam accessories.
Www.Valuehobby.Com/8mm-epp-laser.Html 5 accessories: list: 1. Fiberglass parts including motor mount x 1, control horn x 3, elevator control horn x1. Wheel x 2, landing gear mounting plate x1, aileron servo arm extension x 1, rudder servo arm extension x 1, elevator servo arm extension x 1, pushrod ...
Www.Valuehobby.Com/8mm-epp-laser.Html 6 recommended radio equipment product sku quantity radio flysky t6 transmitter fly-rc-2563 1 servo towerpro sg50 micro servo for rudder and elevator twp-sv -0352 3 recommended power setup product sku motor gforce t2206-1500kv brushless outrunner motor vhb-mt-320...
Section1. Airframe assembly step1. Use foam safe glue to glue the wings to the fuselage. Step2. Glue the carbon fiber square tubing to the pre-cut slot. Step3. Locate the 370mm (14.6-inch) carbon fiber rod, and attach two fiberglass plates to the rod. Step4. Glue the rod to the slot on the tail. Ste...
Www.Valuehobby.Com/8mm-epp-laser.Html 8 step9. Install aileron servo, elevator servo and rudder servo onto the fuselage from the nose to tail. Step10. Slide the vertical fuselage into the horizontal fuselage. Align the tabs from the vertical fuselage into the slots in the horizontal fuselage. Adjust...
Www.Valuehobby.Com/8mm-epp-laser.Html 9 step3. Cut a slot for the horn along the marked line on the aileron. Glue the horn with z-bend wire to the aileron. Step4. Attach the aileron servo pushrod to the aileron servo arm. Step5. Connect the z bend wire and the pushrod together using the shrinking tu...
Www.Valuehobby.Com/8mm-epp-laser.Html 10 step11. Connect the z-bend wire to the elevator control horn step10. Use the foam safe glue to glue the control horn to the tail. Step11. Finish the elevator rudder servo linkage installation using the same method section3. Landing gear installation step1. As...
Www.Valuehobby.Com/8mm-epp-laser.Html 11 section4. Motor and prop installation step1. Install the 2206 motor to the motor mount. Step2. Install 8 x 4 prop to the motor. Step3. Install the battery and electronics to the fuselage. Section5: set up cg and control thro the recommended cg is 218mm (8.6in...
Www.Valuehobby.Com 2014-10-15.
