S s s sbach bach bach bach----342 342 342 342 f3p epp f3p epp f3p epp f3p epp almost-ready-to-fly instruction manual wingspan: 800 mm (31.5 in) length: 790 mm (31.1 in) flying weight: 225-240g (7.9oz-8.5oz).
Www.Valuehobby.Com/sbach342-8mm-epp 2 dear customer, congratulations on your purchase of sbach-342 8mm eppf3p from value hobby. We thank you for your generous support, and hope you enjoy your new airplane. At value hobby, we hope to offer competitive prices, good performance, and products that you c...
Www.Valuehobby.Com/sbach342-8mm-epp 3 safety in flying this is not a toy! It is a very high-performance rc airplane capable of high speeds and extreme maneuvers. It should only be operated by a competent pilot in a safe area with proper supervision. Only fly your aircraft in a safe, open area, away ...
Www.Valuehobby.Com/sbach342-8mm-epp 4 package content: 1. Front horizontal fuselage x 1 2. Rear horizontal fuselage x 1 3. Upper vertical fuselage x 1 4. Lower vertical fuselage x 1 5. Slide force generator x 2 6. Wood parts including aileron servo mount x 1, rudder/elevator servo mount x 2, servo a...
Www.Valuehobby.Com/sbach342-8mm-epp 5 recommended radio equipment product sku quantity radio flysky t6 transmitter fly-rc-2563 1 emax es08a micro servo for aileron emx-sv-0355 1 servo towerpro sg50 micro servo for rudder and elevator twp-sv -0352 2 recommended power setup product sku motor gforce 22...
Section 1: horizontal fuselage installation step1. Install a 700mm (27.6-inch) to the pre-cut slot in the front horizontal fuselage. Step2. Apply some thin ca to secure the carbon fiber square tube to the fuselage. Step3. With the front horizontal fuselage on a flat surface, slide the rear horizonta...
Www.Valuehobby.Com/sbach342-8mm-epp 7 step3. Use the foam-safe ca to glue two slide force generators to the wings. (make sure the slide force generator is perpendicular to the wing.) section 3: servo & linkage installation step1. Locate the aileron servo mount, and install a 9g servo to the mount. S...
Www.Valuehobby.Com/sbach342-8mm-epp 8 step7. Use a shrink tubing to bind the 396mm (15.6-inch) pushrod wire and 33mm (1.3-inch) pushrod wire with z-bend together. It is used as the rudder servo pushrod. Step8. Thread a clevis to the pushrod wire as shown. Step9. Install the rudder servo to the fusel...
Www.Valuehobby.Com 2013-4-3.
