Value Hobby screamer 40 Instruction Manual - page 12
Manual is about: almost ready to fly
of
17
www.valuehobby.com/js-40.html
Section4. Vertical Tail and Tailwheel
Installation
Step1. Insert three CA hinges into the slots in the
rudder. Apply thin CA to the hinges.
Step2. Prepare a tailwheel assembly as shown.
Step3. Cut a groove in the leading edge of the
rudder to accommodate the landing gear wire, and
drill a hole for the vertical shaft.
Step4. Apply epoxy in the groove and the hole for
the tail gear wire, and then glue the tailwheel
assembly to the rudder.
Step5. Glue the fin into position and use a Triangle
to make sure the fin is perpendicular to the
stabilizer.
Step6. Attach the rudder to the fin, and install the
tailwheel to the fuselage using the screws provided
with the tailwheel assembly.