Value Hobby TWEETY - 25 Instruction Manual - page 13
Step 4: Thread the clevis securely onto the elevator
pushrod. We recommend using a clevis retainer to help
keep the clevis in place. Slide the pushrod through the
elevator pushrod exit slot in the fuselage and connect it to
the elevator control horn.
Step 5: With the elevator in the neutral position and the
elevator servo arm perpendicular to the pushrod, mark
where the pushrod crosses the outer hole of the servo
arm. As you did with the rudder pushrods, make a 90
degree bend at the mark and cut off the excess pushrod
1/4" [6mm] beyond the bend. Secure the pushrod to the
servo arm with a FasLink. Make any adjustments
necessary to the nylon clevis so that the elevator is
properly centered and slide the silicone clevis retainer to
the end of the clevis.
Install the Main Landing Gear
Step 1: Locate the four blind nuts in the bottom of the
fuse. Cut the covering from the inside of the holes.
Step 2: Mount the aluminum landing gear to the fuselage.