ValveTrain Amplification 205 User Manual - page 5
ValveTrain Amplification
Page 5
ValveTrain 205 User Manual
Technical Info
Power Requirement:
120 or 240 Volts A.C. (Alternating Current) – Grounded Outlet
Fuse:
1 AMP Slo-Blo on the underside of the Chassis.
Power Output:
Approximately 5 Watts R.M.S.
Tuber Order:
Numbered 1 through 3 from RIGHT to LEFT as you look at the back of
the amplifier.
Preamp Tube:
12AX7 in position 1.
Alternatives: any 12AX7, 12AY7, 12AT7 or 5751
Power Tube:
6V6GT – This tube is located in position 2.
Rectifier Tube:
5Y3GT Rectifier
This is located in position 3.
Speaker Output Load:
8 Ohms. (you may use a 4 or 16 ohm speaker if desired)
Speaker Outputs:
The speaker jack located on the underside of the chassis between Tubes
#1 and #2.
The total recommended load for the amplifier is 8 Ohms. The amps
should operate without damage at 4, 8 or 16 Ohms.
Never run the amplifier without a speaker load connected
Speaker:
Weber Signature Series AlNiCo 8” Speaker at 8 ohms.
Tricks & Recommendations
#1
Learn to use the Volume control on your guitar…
Back it down to cleanup the signal and get clean, shimmering tones.
Open it up to get the distortion that is normally associated with this amps forefather…
(The Fender 5F2 Narrow Panel Princeton)
#2
Use the Low input jack for more clean headroom
#3
Enjoy!!